Linear RE-BWC1 installation instructions Black & White, Cctv Camera, Installation Instructions

RE-BWC1	PRODUCT DESCRIPTION	1. REMOVE CIRCUIT BOARD
	Linear’s Model RE-BWC1 (P/N ACP00886A) CCTV camera can be installed inside
	the RE-1 Entry System. The camera provides a video signal for viewing the area in	DISCONNECT THESE
	front of the entry system	TWO CONNECTORS
Black & White	The camera is continuously powered by the RE-1. The camera’s infrared light emitters		REMOVE
	illuminate the area directly on front of the entry system for nighttime or low light
CCTV Camera	operation.		CIRCUIT
			BOARD
	The camera focus has been factory adjusted to a range of three to four feet.
	The RE -1 CAMERA jack is used to connect the camera to the main circuit board with
	the single-ended modular cable supplied with the camera. This cable routes power to,
	and video from the camera.
Installation Instructions	The RE-1 VIDEO jack is for connection to a video cable with a Type “BNC” connector. Up
	to 300 feet of 75-ohm RG-59 video cable can be used. Longer cable runs may require the
	use of a video amplifi er.
	NOTE: If camera is being installed on an existing installation, power must be off
	prior to removing circuit board.
(760) 438-7000		REMOVE THESE
USA & Canada (800) 421-1587 & (800) 392-0123		4 SCREWS
Toll Free FAX (800) 468-1340
www.linearcorp.com
2. MOUNT THE CAMERA	3. CONNECT LIGHTING POWER	4. REPLACE CIRCUIT BOARD
SECURE THE CAMERA ASSEMBLY			RECONNECT THESE
WITH TWO SCREWS		REPLACE	TWO CONNECTORS
		CIRCUIT
		BOARD
	INSERT WIRING
	HARNESS PLUG
	INTO THE 2-PIN
IMPORTANT!	LIGHTING
	CONNECTOR
TO PREVENT INTERNAL
INFRARED LIGHT FROM
ENTERING THE CAMERA,
BE SURE THE FOAM GASKET
AROUND THE CAMERA'S		SECURE WITH
LENS PRESSES FIRMLY AGAINST
		4 SCREWS
THE RE-1'S FACEPLATE
5. CONNECT CAMERA CABLE	6. CONNECT VIDEO CABLE	LINEAR LIMITED WARRANTY
		This Linear product is warranted against defects in material and workmanship
PLUG THE CAMERA CABLE		for twenty four (24) months. The Warranty Expiration Date is labeled on the
		product. This warranty extends only to wholesale customers who buy direct from
INTO THE CAMERA'S JACK
		Linear or through Linear’s normal distribution channels. Linear does not warrant
AND THE RE-1'S CAMERA JACK	CONNECT THE VIDEO CABLE FOR THE MONITOR
		this product to consumers. Consumers should inquire from their selling dealer
	TO THE RE-1'S VIDEO OUTPUT CONNECTOR	as to the nature of the dealer’s warranty, if any. There are no obligations or
		liabilities on the part of Linear LLC for consequential damages arising
		out of or in connection with use or performance of this product or other
		indirect damages with respect to loss of property, revenue, or profit, or
		cost of removal, installation, or reinstallation. All implied warranties, including
CAMERA		implied warranties for merchantability and implied warranties for fi tness, are valid
CABLE FROM		only until Warranty Expiration Date as labeled on the product. This Linear LLC
CAMERA'S JACK		Warranty is in lieu of all other warranties express or implied.
		All products returned for warranty service require a Return Product Authorization
	RE-1	Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an
		RPA# and other important details.
	CAMERA
	JACK
		Copyright © 2007 Linear Corporation	227793 A