Horizontally or Vertically Mounting the H585

H585 INSTALLATION MANUAL

HORIZONTALLY OR VERTICALLY MOUNTING THE H585

H585 INSTALLATION MANUAL

In order to install the H585 in the H588, the H585’s Trim Brackets must first be mounted to the front of the H588 as shown.

See Figure 2.

The H585 ships ready for horizontal installation. Should you choose to mount the H585 vertically, the H588 must also be mounted vertically and the camera module must be rotated 90 degrees.

NOTE: Regardless of the H585’s orientation, always make sure the wire protruding from the rear of the camera module is located in the UPPER-RIGHT corner when viewed from the rear! See Figure 3

Once the camera module has been repositioned, be sure to tighten the bracket screw, securing the camera in the desired position.

ADJUSTING THE VIEWING ANGLE

The camera's viewing angle may also be adjusted +/- 15 degrees by carefully twisting the Camera Bracket.

POWERING THE H585 FROM A REMOTE LOCATION

Most installations will require the H585 be powered from a remote location (i.e. the main equipment location).

Figure 2 - Mounting the H585’s Trim Brackets. Note the orientation of the Trim Bracket’s inner flanges.

Camera

Bracket

Set

Screw

Camera

Wire

1.Use pliers or a 7/16 wrench to loosen the Set Screw and rotate the camera.

2.Make sure the Camera Wire is located in the upper right corner when the H585 is viewed from the rear.

3.Adjust the viewing angle by carefully twisting the Camera Bracket.

Figure 3 - Whether mounted horizontally or vertically, the Camera Wire should always protrude from the UPPER-RIGHT corner when the H585 is viewed from the rear.

BRAND X

ELECTRONIC DOOR LATCH MECHANISM

DOORBELL

BUTTON

(INCLUDED)

To accomplish this, remove the power connector from the power supply (included) and the H585 as shown to the J-Box wires - be sure to maintain proper polarity on these and the remotely located power supply connections. NOTE: DO NOT remove the H585 yellow (video) RCA jack connector!

An "F-to-RCA" barrel connector is included to facilitate the connection of RG-6 or RG-59 coax cable to the H585’s RCA composite video connector.

(Remove)

BLACK = ( - )

18/2 (for Power)

RED = (+)

12VDC

800mA

To	WHITE STRIPE
Video Modulator	is POSITIVE (+)

Figure 4 - Extending the H585’s power supply cable using 18/2.

Figure 5 - Connecting the H585 to an H560 amplifier. NOTE: 22 or 24 AWG 4 twisted pair wire with shield is

utilized so the color codes are not called out. Be sure to wire carefully as shown!

Page 2

Page 3