Diffuser & Deflector Installation, Substrobe DS51

Diffuser & Deflector Installation

Diffuser

Housing shown with

Diffuser installed.

Optional Accessories

Back O'ring #0109

O'rings last for several years if properly maintained. (See

Diffuser and Deflector cont.		Diffuser/
Diffuser and Deflector cont.		Deflector
A diffuser and deflector are		material
included with the housing.
The diffuser is white
transparent plastic. The
deflector is also white but is
not transparent and has a
decal on the front.		Port Clamp
To install the diffuser or		Port Clamp
To install the diffuser or		Spring
deflector spread the port
clamp at the spring end and
slide over the lens port. The	This edge
white plastic should be	against	Spread to Install
placed in front of the camera	housing
flash. The port clamp should

be pushed back against the front of the housing.

Diffuser

The diffuser should be installed when using the camera's built in flash. When shooting with the camera's built-in flash at approximately 2 feet (0.6 m) or less, the lens port on the housing may block a portion of the light from the camera's built-in flash, creating a shadow in the lower left of the photo. If this occurs, zoom the lens slightly to eliminate the shadow. (You can test this above water)

Deflector

The deflector should be installed when using an external strobe such as the DS51 or DS125 Substrobe and EV Controller. The deflector will redirect the camera's flash to the EV Controller which controls the external strobes output.

Optional Accessories Continued

maintenance) Always carry a spare.

UR/Pro Filter #6441.32

The UR/Pro underwater color correcting filter is designed to restore some of the warm colors filtered out by the water. For available light use only, not recommended for use with flash.

Use the EV Controller with a DS Substrobe

The EV Controller provides 10 manual power settings in 1/2 stop increments for the DS51 or DS125 Substrobes. The EV Controller has a built-in slave which can be triggered by the camera's built-in flash.

Substrobe Packages available

#3944.47 SubStrobe DS51 with EV Controller & Strobe Arm #3944.54 SubStrobe DS51 with EV Controller & Ball Socket Arm #3944.77 SubStrobe DS125 with EV Controller & Ball Socket Arm

Substrobe DS51

EV Controller

Substrobe

DS125

SA-100Q

Arm

SA-100Q

Arm

EV Controller

Substrobe DS51
The Substrobe DS51 covers the
equivalent of a 28mm lens. It is
the ideal choice when using
only the camera lens or the
camera lens with a macro
accessory lens.	11
	11

Substrobe DS125

The Substrobe DS125 covers the equivalent of a 18mm lens, 100 degrees. It is the ideal choice when using accessory wide angle lenses greater than 28mm.