Ikelite IXUS65 Diffuser & Deflector Installation, Optional Accessories Back Oring #0109

Page 4
Spring
Spread to Install
against housing

Diffuser & Deflector Installation

Diffuser

Housing shown with

Diffuser installed.

8

Optional Accessories

Back O'ring #0109

O'rings last for several years if properly maintained. (See maintenance) Always carry a spare.

UR/Pro Filter #6441.32

The UR/Pro underwater color correcting filter is designed to restore some of the warm colors filtered out by the water. For available light use only, not recommended for use with flash.

Use the EV Controller with a DS Substrobe

The EV Controller provides 10 manual power settings in 1/2 stop increments for the DS51 or DS125 Substrobes. The EV Controller has a built-in slave which can be triggered by the camera's built-in flash.

Substrobe Packages available

Ikelite Ball Arm Systems are provided with these packages #3944.54 SubStrobe DS51 with EV Controller

#3944.77 SubStrobe DS125 with EV Controller

Diffuser and Deflector cont.

Deflector

A diffuser and deflector are

 

Diffuser/

 

material

included with the housing. The

 

diffuser is white transparent

 

plastic. The deflector is also

 

 

white but is not transparent

 

and has a decal on the front.

 

To install the diffuser or

This edge

Port Clamp

 

 

deflector spread the port clamp at the spring end

and slide over the lens port. The white plastic should be

placed in front of the camera flash. The port clamp should be

pushed back against the front of the housing.

Diffuser

The diffuser should be installed when using the camera's built in flash. When shooting with the camera's built-in flash at approximately 2 feet (0.6 m) or less, the lens port on the housing may block a portion of the light from the camera's built-in flash, creating a shadow in the lower left of the photo. If this occurs, zoom the lens slightly to eliminate the shadow. (You can test this above water)

Deflector

The deflector should be installed when using an external strobe such as the DS51 or DS125 Substrobe and EV Controller. The deflector will redirect the camera's flash to the EV Controller which controls the external strobes output.

9

Optional Accessories Continued

Substrobe

DS125

Substrobe

DS51

SA-100Q

Arm

SA-100Q

Arm

EV Controller

EV Controller

10

Substrobe DS51

 

The Substrobe DS51 covers the

equivalent of a 28mm lens. It is

the ideal choice when using

 

only the camera lens or the

 

camera lens with a macro

 

accessory lens.

11

 

Substrobe DS125

The Substrobe DS125 covers the equivalent of a 18mm lens, 100 degrees. It is the ideal choice when using accessory wide angle lenses greater than 28mm.

Image 4
Contents Digital Housing Opening the Housing Installing the CameraClosing the Housing Checking ControlsTurn Camera On LubricantsDiffuser & Deflector Installation Optional Accessories Back Oring #0109Optional Accessories UR/Pro Filter #6441.32Maintenance Control MaintenanceIkelite Limited Warranty Returning Products for ServiceGeneral Tips Photo Tips