Ikelite Coolpix L1 instruction manual Optional Accessories, Maintenance

Optional Accessories Substrobe DS51 Package #3944.57

The Substrobe DS51 package includes the Substrobe DS51, the EV Controller and ball socket arms. The EV Controller provides 10 manual power settings in 1/2 stop increments. An external strobe offers several advantages over using the camera’s built-in flash. External strobes move the flash away from the camera lens which helps reduce backscatter. They also expand lighting options to achieve the best lighting for different subjects. A second external digital strobe package can be added to fill the shadows and produce more realistic photographs.

The Substrobe DS51 covers the equivalent of a 28mm lens. It is the ideal choice when using only the camera lens or the camera lens with a macro accessory lens.

If an accessory wide angle lens wider than 28mm is used, the ideal lighting choice is the Substrobe DS125, which covers 100 degrees, or two Substrobe DS51’s can be used.

12

Substrobe

DS51

Ball Socket

Arm

EV Controller

NOTE:

Optional Tray and Release Handle required to mount Substrobes.

Optional Accessories

Substrobe DS125 Package #3944.77 The Substrobe DS125 package includes the Substrobe DS125, the EV Controller, ball socket arm and charger. The EV Controller provides 10 manual power settings in 1/2 stop increments. An external strobe offers several advantages over using the camera’s built-in flash. External strobes move the flash away from the camera lens which helps reduce backscatter. They also expand lighting options to achieve the best lighting for different subjects. A second external digital strobe package can be added to fill the shadows and produce more realistic photographs.

The Substrobe DS125 covers the equivalent of a 18mm lens, 100 degrees. It is the ideal choice when using accessory wide angle lenses greater than 28mm.

13

Substrobe

DS125

Ball Socket

Arm

EV Controller

NOTE:

Optional Tray and Release Handle required to mount Substrobes.

Maintenance
The Ikelite Digital Housing should be given the same care and
attention as your other photographic equipment. In addition to
normal maintenance we recommend that the housing be returned
to Ikelite periodically to be checked and pressure tested.
1.	Do Not leave the camera and housing in direct sunlight for
2.	prolonged periods. Heat may damage the camera.
	Do Not ship the camera in the housing.
3.	Before using the housing, always check the tightness of the set
	screw in each control knob.
	Check each control gland penetrating the housing to make sure
	they are tight. There is a slight chance that either could vibrate
4.	loose during travel.
	Keep the back o’ring clean and lightly lubricated. To lubricate
	remove the o’ring from the back. Put a small amount of lkelite
	lubricant on your fingers. Draw the o’ring through your fingers
	to apply a light coating of lubricant. Only apply enough
	lubricant to make the o’ring feel slick. Do Not stretch the o’ring.
	This light coating of lubricant will help to keep the o’ring from
	drying out and will help to show a dark sealing line when the
5.	housing back is properly sealed.
	Keep the area where the o’ring fits and the sealing surface of
6.	the housing clean.
	Rinse the housing exterior thoroughly in fresh water after each
	salt water use. Dry with a soft cloth. Dry lens port to eliminate
	water spotting.
	After several uses in salt water soak the housing exterior in a
	mild soap solution, rinse and dry before storage. When storing
	the housing, remove the back o’ring, lightly lubricate and place
	in a plastic bag. Place the plastic bag with o’ring inside the
	housing for safe keeping.
CAUTION
	Never use spray lubricants as the propellant ingredient can	14
	cause the plastic housing to crack.