Software Notes
Please ensure that you read the instruction manual carefully before use.
•The attached software is a camera driver and image editing software tool for Windows.
•Under no circumstances should all or part of either the software or the user manual be reproduced.
•Copyrights for software are licensed only for use with a camera.
•In the unlikely event of a manufacturing fault, we will repair or exchange your camera.
We cannot, however, be held responsible in any way for damage caused by inappropriate use.
•Using a
•Before reading this manual, you should have a basic knowledge of computers and O/S (Operating Systems).
System Requirements
For Windows | For Macintosh | |
PC with processor better than Pentium II 450MHz | Power Mac G3 or later | |
(Pentium 700MHz recommended) | ||
| ||
|
| |
Windows 98 / 98SE / 2000 / ME / XP | Mac OS 10.0 ~ 10.3 | |
|
| |
Minimum 64MB RAM | Minimum 64MB RAM | |
200MB of available hard disk space | 110MB of available | |
|
| |
USB port | USB port | |
|
| |
|
| |
1024x768 pixels, 16bit color display | For playing back a movie clip | |
compatible monitor | Mac OS 10.1 or later | |
(24bit color display recommended) | MPlayer | |
|
|
About the software
After inserting the
Before connecting the camera to the PC, you should first install the camera driver.
※Screen Captures illustrated on this manual is based on English Edition of Windows.
■Camera driver : This enables images to transfer between the camera and PC. This camera uses the USB Storage Driver as the camera driver. You can use the camera as a USB card reader. After installing the driver and connecting this camera to the PC, you can find [Removable Disk] in [Windows Explorer] or [My computer]. A USB Storage Driver is provided only for Windows. A USB Driver for MAC is not included with the Application CD. You can use the camera with Mac OS 10.0 ~ 10.3.
■Digimax Master : This is the
INFORMATION
●Be sure to check the system requirements before installing the driver.
●You should allow 5 ~ 10 seconds for running the automatic setup program according to the capability of your computer. If the frame does not show, run the [Windows Explorer] and select [Samsung.exe] in the
《74》