ADJUSTING THE SUBWOOFER BEFORE USE
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and the front speakers by following the procedures described below.
Subwoofer rear panel
3
1 Set the VOLUME control to minimum (0).
2 Turn on the power of all the other components.
3 Press the POWER switch to the ON position. * The Power indicator lights up in green.
4 Play a source containing bass signal and adjust the amplifier’s volume control to the desired listening level.
5 Set the HIGH CUT switch to the LOW or HIGH position. This subwoofer is designed so that the optimum tone balance between the subwoofer and the front speakers is obtained when this switch is set to the LOW position. The tone balance may change, however, depending on the room size, the distance from the subwoofer to the front speakers, and so on. If necessary, switch it to the HIGH position.
1,6
OUTPUT | INPUT | HIGH |
TO SPEAKERS | 2 | CUT |
| /MONO |
|
|
| VOLUME |
|
| HIGH LOW |
INPUT 1
FROM AMPLIFIER
5
6 Rotate the VOLUME control gradually to adjust the volume balance between the subwoofer and the other speakers.
*Normally, set the control to the level where you can obtain a little more bass effect than when the subwoofer is not used. If the desired response cannot be obtained, adjust the HIGH CUT switch and the VOLUME control again.
Notes
•Once the volume balance between the subwoofer and the front speakers is adjusted, you can adjust the volume of your whole sound system by using the amplifier’s volume control.
However, if you change the front speakers to others, you must make this adjustment again.
•For adjusting the VOLUME control, the HIGH CUT switch, refer to “Frequency characteristics” on page 10.
9