U S I N G Y O U R Q E / Q V H E A D S E T
Slide the foam windscreen over the microphone ,as shown in the illustration on the previous page, to eliminate wind noise.
The PM4 phantom power adaptor with its special interface, enables a mixer to provide phantom power to condenser, piezo or electric microphones. The PM4 converts high impedance (50 k – 10meg ohm) to low impedance (600 ohms) allowing long cable runs without noise and gain loss.
Connect the P3 plug from your QE/QV Headset into the locking input of the PM4. Connect an XLR cable from the PM4 to the input of your mixer. Clip the PM4 to your belt loop or some other part of your clothing, as in the photos on the box cover, as not to cause strain by pulling on the wire coming from the headset. You should also select a thin, lightweight XLR cable for this interface.
9