Samsung L100 manual Drive mode

High resolution and picture quality increases file saving time, which increases stand-by time.

Setting up the recording function using the camera buttons

Drive mode

„You can select continuous shot, and AEB (Auto Exposure Bracketing).

[Single] ()	: Take one picture only.
[Continuous] ()	: Images will be taken
	continuously until
	the shutter button is
	released.
[AEB] ()	: Take three pictures	DRIVE
	in a series in different	Single
	exposures: standard
	exposure (0.0EV), short exposure (-1/3EV) and
	over exposure (+1/3EV).
	Use this function when you cannot determine the
	exposure value of subject.
[Motion Capture] () : This takes 6 shots per second, and for max 5
	seconds, when the shutter is pressed and held
	down. The maximum number of shots is 30 and
	the image size is fixed as VGA.

ξ

ξIf the [Continuous], [AEB] or [Motion Capture] sub menu is selected, the flash will be off automatically.

ξIf less than 3 pictures are available in the memory, the [AEB] shooting is not available.

ξIt is best to use a tripod for the [AEB] shooting as the time to save each image file is longer and blurring caused by camera shake may occur.

ξIf less than 30 pictures are available in the memory, the [Motion Capture] shooting is not available.

ISO

„You can select the ISO sensitivity when taking pictures.

The speed or specific light-sensitivity of a camera is rated by ISO numbers.

[Auto] () : The camera’s sensitivity is
automatically changed by
variables such as lighting value		ISO
or subject brightness.
	Auto

[ISO 80, 100, 200, 400, 800, 1600] (

) :

You can increase the shutter speed while the same amount of light is present, by increasing the ISO sensitivity. However, the image may be saturated in high luminance.

The higher the ISO value, the higher the camera’s sensitivity to light and therefore the greater its capacity to take pictures in dark conditions. However, the noise level in the image will increase as the ISO value increases, making the image appear coarse.

41