Main Selection Menu | Bowens BWL-0335/2 manual

The Main Selection Menu	QUADX

The Main Selection Menu offer the ability to control and adjust the following common functions.

1.	Modelling	MAIN	SELECTION MENU
2.	Bracketing
			BRACKETING	MODE
3.	Speaker On/Off
		>	MODELLING	MODE
4.	IR Channel
			SPEAKER ON/OFF

The Main Selection Menu (Cont.)

The unit is considered to be in Bracketing Mode when the display indicates Bracketing Options or Bracketing Mode. Under these conditions the unit will automatically check and warn if the selection is not possible within the existing setting constraints. A warning occurs if the bracket setup will take the unit outside of its normal operating range.

Bracketing Mode Example

As an example, assume a single head in socket A1 set for 7.0. First select 0.3 stop bracket step. Now select Low to High by scrolling and pressing .

It also provides the entry point into the Advanced Menu. Menu choice is denoted by the > character which always defaults to Modelling when coming from the Information Menu.

To select an item, use the & buttons to scroll the screen until the > character is aligned with the

item required. Press	to select the item. The * character will move to indicate the new mode of
operation.

Modelling.

Automatic 100% and Full (100%) have the further option to apply a dimming bias. Upon selection of

these modes, press again to enter the bias control menu. From here use the & buttons to adjust the value.

In all cases use to go back.

Modelling Option Summary:
Modelling Mode	Lamp Proportional
Modelling Mode	Automatic 100%	Lamp Dimming Mode (Bias)
Modelling Mode	Full (100%)	Lamp Dimming Mode (Bias)
Modelling Mode	Cont / Int / Off Modes	Selection of A1,A2,B1,B2, All

If Cont / Int. / Off is selected, a new menu will be revealed to allow mode adjustment of each socket i.e. Continuous, Intermittent or Off. This is also reflected by the Red display.

Adjustment is made by pressing the right arrow key at each line of selection. The ALL value represents a quick way to adjust all the lamps together. This will change to USER SET if any lamp is set differently to any other.

Bracketing.

Bracketing allows three consecutive shots to be taken at power levels above, at and below the current setting level. The bracketing sequence may be arranged to start at a low power working upwards or alternatively may begin at a high power and work downwards. The forst thing to do when using bracketing is to ensure that you have set the bracket step. Scroll as follows:

Bracketing Set Bracket Step. Now use & to adjust the number from 0.1 stop to 0.9 stop.

Press when set.

The screen indicates the first flash will occur 0.3 stop below the present power setting and the final flash will be 0.3 stop above the present power setting. At any

time, pressing will take you back and out of the bracketing mode.