Samsung BW-4302 instruction manual Troubleshooting, Specifications

Troubleshooting

If you have trouble operating your camera, refer to the following. If the guidelines do not enable you to solve the problem, contact an authorized technician.

Problem		Solution
Nothing appears	• Check that the power cord and line connection
on the screen.	between the camera and monitor are made properly.
	• Check that the VIDEO/ESC selection switch on the
	rear of the camera set to a proper position according
	to the type of your lens.
The image on the	• Check if the lens are stained. If dirty, clean the lens
screen is dim.	with soft, clean cloth.
The camera is	• Check that you have connected the camera to a
not work	proper power.
properly, and the	– AC 24V, 60Hz	: BW-4302EA
surface of the
camera case is	– AC 24V ~, 50Hz	: BW-4302CA
hot.	– AC 230V ~, 50Hz	: BW-4302CH
The contrast on	• Adjust the contrast feature of the monitor. If the
the screen is too	camera is exposed under too strong light, change the
weak.	camera position.
The image on the	• Does the camera face to directly to the sun or
screen flickers.	fluorescent lighting? Change the camera position.
The image on the	• Check that you have used 50Hz (CCIR models) and
screen is	60Hz (EIA models) in linelock (L.L) mode. If the power
distorted.	frequency is out of 50Hz (CCIR models)
	/60Hz (EIA models), the linelock(L.L) synchronization
	mode cannot be used. Use the Synchronization Mode
	to INT mode.

Specifications

ITEM	BW-4302EA	BW-4302CA		BW-4302CH
POWER SOURCE	AC24V, 60Hz	AC24V, 50Hz		AC230V, 50Hz
POWER CONSUMPTION	4W	4W		4W
	INT/Linelock
	seclectable	INT/Linelock seclectable
SYNC. SYSTEM	(Phase: 0~270	(Phase: 0~270 Power frequency:
	Power frequency:	50Hz only)
	60Hz only)
PICK-UP DEVICE	768(H) 582(V)1/3” BW CCD	752(H) 582(V)1/3” BW CCD
SCANNING SYSTEM	2:1 Interlace	2:1 Interlace
	525Lines	625Lines
MINIMUM ILLUMINATION		0.05 Lux at F1.2
RESOLUTION		570(H)TV Lines
VIDEO OUTPUT	1.0 Vp-p EIA Comp.	1.0 Vp-p CCIR Comp.
Backlight Compensation	Center/Full Selectable
IRIS MODE	VIDEO/ESC/DC Selectable
ELECTRONIC IRIS		1/60~1/100,000 Sec
LENS	C/CS MOUNT Changeable
GAMMA CORRECTION		0.45
AGC		Built-in 28dB
APERTURE CORRECTION		Built-in
S/N RATIO		50dB
AMBIENT TEMPERATURE	-10	+50 14	122
DIMENSION	55(W) 57(H) 136(L)mm(Without Lens)
WEIGHT	440g(Without Lens)	450g(Without Lens)		500g(Without Lens)
ACCESSORY	IRIS JACK, MANUAL, L-WRENCH

24 B W CCD CAMERA B W CCD CAMERA 25