Kodak GE1900C user manual Gpo, Item 3 Mini-SMB Trigger Input

Page 9

GE1900 User Manual

70-0028A-A

Sync Out 2 and Sync Out 3

These signals only function as outputs and can be configured as follows:

Exposing

Corresponds to when camera is

 

integrating light.

Trigger Ready

Indicates when the camera will accept a

 

trigger signal.

Trigger Input

A relay of the trigger input signal used

 

to “daisy chain” the trigger signal for

 

multiple cameras.

Readout

Valid when camera is reading out data.

Strobe

Programmable pulse based on one of the

 

above events.

Imaging

Valid when camera is exposing or

 

reading out.

GPO

User programmable binary output.

Any of the above signals can be set for active high or active low.

RS-232 RXD and RS-232 TXD

These signals are RS-232 compatible. These signals allow communication from the host system via the Ethernet port to a peripheral device connected to the camera.

ISOLATED GROUND

These signals are internally connected to isolated ground. At least one of these signals must be connected to the users external circuit ground. However, it is good practice to provide a dedicated ground return for each signal used. For example, a good cable design would connect the required signal on one conductor of a twisted pair and the isolated ground on the second conductor of the same twisted pair.

DNC

These signals are reserved for future use and should be left disconnected.

Item 3: Mini-SMB Trigger Input

The Mini-SMB port on the camera uses an Amphenol 903-406J-51R connector. A suitable mating cable connector is Amp 413985-3 which can be used with RG174 coaxial cable. Contact Prosilica to purchase cabling.

The Mini-SMB Trigger Input is internally connected to the Trigger Input (Pin 1) of the General Purpose I/O Port (Item 2 above). Therefore see this section for more detail.

Prosilica Inc.

7

Image 9
Contents November 1 ProsilicaTable of Contents Precautions WarrantyIntroduction Specifications BGR24, RGBA24, BGRA24 Supported FeaturesMM Deep Plcs TYP MechanicalConnections GE Series connection diagramItem 2 General Purpose I/O Port Item 1 Gigabit Ethernet PortItem 3 Mini-SMB Trigger Input GPOItem 4 Mini-SMB Sync Out Item 5 Status LEDItem 6 Status LED Item 7 Auxiliary Power Port Cleaning with Air Cleaning the SensorContact Cleaning Identifying DebrisAdjusting the C-mount Loosen Locking RingImage to Infinity Computer Interface Camera InstallationNetwork card main properties window Gigabit Ethernet Setup for WindowsNetwork card TCP/IP address Power Connection Gigabit Ethernet CablingOther Cabling GigE Viewer application window Installing GigE Viewer for TestingSystem Optimization Network card advanced settings Driver Issues Trouble ShootingCheck the Basics Test the Camera with the Prosilica Viewer