Removing the Friction Cap
The Friction Cap needs to be removed to either install or change the stainless steel detent discs. These discs provide the means for estab- lishing and changing the number and spacing of the angular incre- ments of the tripod head. Most KiWi models come with two discs, one for the standard lens and one for a
Lenses in Appendix A and List of Detent Discs in Appendix C ).
To remove the Friction Cap, loosen the stainless steel Retaining Knob which is located on the side of the Friction Cap. It does not have to be removed from the Cap, but only backed out far enough to allow the cap to be unscrewed from the axle. You can look into the opening in the center of the cap to see when the Retaining Knob is clear of the
Vertical
Bracket
Hexagonal Shaped Axle
Friction Cap
Retaining Knob
Hexagonal Shaped Axle
Indexing Hub