Zebra Technologies P1061668-001 Print Mode Data Characters and Escape Sequences, Esc #E, Esc #R

30

Kiosk Modifications of the OLE for Retail POS

General Information

Table 9 • One Shot Data Characters and Escape Sequences (Continued)

Name	Data	Remarks	Zebra Kiosk
			Printer Supported
Feed units	ESC #uF	Feed the paper forward by mapping	NO
		mode units. The character ‘#’ is
		replaced by an ASCII decimal string
		telling the number of units to be fed. If
		‘#’ is omitted, then one unit is fed.
Feed reverse	ESC #rF	Feed the paper backward. The	NO
		character ‘#’ is replaced by an ASCII
		decimal string telling the number of
		lines to be fed. If ‘#’ is omitted, then
		one line is fed.

Print Mode Characteristics that are remembered until explicitly changed.

Table 10 • Print Mode Data Characters and Escape Sequences

Name	Data	Remarks	Zebra Kiosk
			Printer Supported
Pass through	ESC #E	Send the following # characters of	NO
embedded data		data through to the hardware without
		modifying it. The character '#' is
		replaced by an ASCII decimal string
		telling the number of bytes following
		the escape sequence that should be
		passed through as-is to the hardware.
Print in-line barcode	ESC #R	Prints the defined barcode in-line. The	NO
		character ‘#’ is the number of
		characters following the R to use in
		the definition of the characteristics of
		the barcode to be printed. See details
		below.
Font typeface selection	ESC #fT	Selects a new typeface for the	YES
		following data. Values for the	The Kiosk OPOS driver
		character ‘#’ are:	has 2 fonts implemented.
		0 = Default typeface.
			Valid selections are 0 for
		1 = Select second typeface from the
			(small) Monospace, 1 for
		FontTypefaceList property.
			Lucida Console (big)
		2 = Select third typeface from the
		FontTypefaceList property.
		And so on.

P1061668-001 Rev. A OPOS Driver User Guide 11/25/2013