Surface Mount Installation:
1.Locate suitable mounting location in the rear center of the vehicle and use the support bracket (# 2) as a template to mark and drill two 5/32” holes on the mounting location.
2.Put the support bracket (# 2) onto the camera neck, then screw the lock nut along the camera neck to secure the bracket (# 2) to the camera body (# 1) in the showed direction.
3.Screw the combine screws (or tapping screws) into the holes to attach the camera support bracket to the vehicle with the camera cable facing downwards.
4.Place the protective cover (# 4) on the support bracket, then place the flat washer 1 (# 6) and top cover (# 5) on the camera neck. Tighten the top cover (# 5) to the further location along the camera neck towards the camera body.
5.Route the camera cable thru an existing grommet into the vehicle.
6.Connect the camera cable to the extension cable and route towards the monitor.
10
128-6951
11 of 12