Batteries Installation, Suite | Argus Camera DC 1600 manual

Batteries Installation

1.Open the battery door at the back of your camera.

2.Install 3 x AAA Alkaline batteries into Digital Camera, as shown.

3.Make sure to orient the positive (+) and negative (-) ends of the batteries exactly as shown.

4.Replace the door.

CAUTION – To avoid battery leakage:

•Non-rechargeable batteries are not to be recharged.

•Be sure to insert the battery with the correct polarities according to battery manufacturer’s instructions.

•Remove the battery from product before extended storage.

•Always remove an old or dead battery from the product.

•Do not short-circuit the supply terminals.

•Check that the contact surfaces are clean and bright before installing the battery.

Prepare to Upload the Photos

Installing Digital Camera CD-ROM Software

•Insert the CD-ROM disc into your drive.

•The installation will start automatically.

•Follow the installation instructions.

•You can choose any of the three Arcsoft software – PhotoFantasy, PhotoStudio & Photo Printer.

•After installation is complete, click ‘Finish’ button to install the Digital Camera driver.

•The system must be restarted to complete the installation.

•Click ‘Start’ from the Windows Taskbar, then search through ‘Programs’/Digital Camera

•Choose any of the three Arcsoft software to run it.

•Click ‘Start’ from the Windows Taskbar, then search through ‘Programs’/Digital Camera

Suite.

•Click the Uninstall icon and follow the on-screen prompts.

Or you can uninstall the software with the following steps:

•Click ‘Start’ from the Windows Taskbar, then click on ‘Setting’.

•Double click on ’Add/Remove Programs’.

•Scroll down and highlight ‘Digital Camera Suite’.

•Click on ’Add/Remove Programs’ and the ’OK’.