Troubleshooting | Argus Camera DC3200 specification

1. No Power

2. No Photo is taken

3. Can't use flash

4. Image too dark with flash

5. Image is blurred

6. Can't erase the photo It is protected.

7. LCD monitor is off

8. No display on the status LCD

9. Card Full is seen No CF card is inserted.

10. The object is too dark

11. The object is unclear Environment too dark.

12. The object color is too yellow

13. I cannot use the CF card

Troubleshooting :

Before you decide the camera is faulty, check the following hints or instructions.

The battery is exhausted, inverted polarities The internal memory or CF card is full

1. It is set to suppress flash mode

2. Battery power is low.

1. The subject is too far away

2. Your fingers covered the flash. The lens is soiled

Unprotect it.

The Mode Dial is set incorrectly

The camera is auto power off

The card is full

1. Change the position to avoid backlit problem.

2. Use eV compensate. Add 1eV or 1.5eV.

Use flash or tripod.

Change the White Balance to other settings. 1. Power off and then turn on the unit.

2.Check if the CF card is fully inserted.

14.I cannot use the video camera Make sure you have selected 'silent video'

modemode

15. I am using “Easy-CD Creator 1.DC3200 Digital Camera’s installation CD

(version 4.X or below) and I	includes an “auto-check” program to detect
have problem installing the	if your PC has any software conflicts
camera driver, what should	between PC’s own devices and the camera.
I do?	If the “auto-checker” detects existence of
	software conflicts, it will recommend and
	guide the user to download the updated
	driver/file from appropriate website to solve
	the conflict problem.
	2.If you cannot download the driver from
	website for some reasons, try following the
	following procedures:
	a. Insert the DC3200 Digital Camera
	installation CD into the CD-ROM drive
	b. Look for the file “recover.bat” stored in
	the CD
	c. Double-click the file to initiate the
	recovering process
	d. Restart your computer