GIMBAL MOUNT OPTION
You may want to mount the Aqua-Vu monitor on the console (or in the electronics locker) of your boat, or somewhere other than on the portable carrying shuttle that comes with the unit. You can easily make the switch. You'll need a Gimbal Bracket that can be purchased from Aqua-Vu dealers or online at www.aquavu.com. With a Gimbal Bracket in the desired place, loosen the two thumbscrews holding the monitor to the Aqua-Vu Z unit, remove the monitor, and (using the two thumbscrews) attach it to the Gimbal Bracket.
VIDEO RECORDING WITH THE AQUA-VU Z
Your Aqua-Vu Z's "VIDEO-OUT" jack is for connecting your unit to a handheld camcorder, or to a larger external monitor. Your Aqua-Vu will work with any camcorder or any monitor that accepts the NTSC video signal (the North American standard) and has a "VIDEO-IN" jack. Use an RCA-style patch cord that comes with most camcorders (also available at most consumer electronics stores.) For video recording, plug one end of the cord into the "VIDEO-OUT" jack on the Aqua-Vu; plug the other end into the "VIDEO-IN" jack on your camcorder. You should be able to watch your Aqua-Vu monitor and record at the same time.
CARING FOR YOUR AQUA-VU Z
Your Aqua-Vu underwater viewing system requires minimal "common sense" maintenance.
1.The battery requires regular charging. (See battery charging instructions.) Always disconnect the red and black power leads before charging the battery. Never charge while the unit is connected.
2.Clean the monitor and camera lens periodically by using mild dishwashing soap, warm water, and a very soft cloth. Do NOT use window cleaner or alcohol-based products, since they may cause permanent fogging.
3.Periodically run your fingers over the entire length of the cable, feeling for nicks or other cable damage. A damaged cable should be returned to the factory for repair. (See the Service section of this manual.)
4.As a precautionary measure, dry off your monitor after it gets wet from rain or boat spray.
5.Never tug on fishing line that accidentally gets wrapped around the camera cable. Line can cut and damage the cable.
Nature Vision, Inc. © Copyright 2000 Pg 6