Installation

TEDDY CAM

1.The Teddy Cam can be powered by either a 9 volt battery or with the included AC Adapter.

2.Move the Teddy Cam to the desired location.

NOTE: The transmission range of the Teddy Cam is up to 150ft. Real distance depends on its operating environment. If you are receiving interference, try shortening the transmission range. Reposition and/or adjust the Teddy Cam if video transmission is being degraded by obstructions in its operating environment.

3.Select the desired transmission channel for the Teddy Cam.

NOTE: The Teddy Cam has four different transmission channels. Do not use more than one video camera on the same channel. Doing so will result in interference and an unclear picture.

•The transmitter is located inside the back of the bear. Unzip the zipper and pull out the transmitter. Set the switch to the desired channel (1-4)

5.Place a 9V battery into the battery compartment. Use only alkaline batteries for the Teddy Cam. The Teddy Cam can also be powered using the the AC Power Adapter. Plug it into the adapter jack, then plug the AC Power Adapter into a standard 120V/230VAC electrical outlet.

NOTE: Make sure to take the battery out of the battery compartment before plugging in the AC Power Adapter.

7. Slide the Power ON/OFF Switch to the ON position.