Cables

Connecting Fiber Cable

When connecting fiber cable to a 1000Base-FX port on the converter, be sure an SC or WDM connector is used. (Other INTELLINET NETWORK SOLUTIONS Media Converter models may need cable that matches their ST ports.) Follow the steps below to properly connect fiber cable.

1.Remove and keep the fiber port’s rubber cover. When not connected to a fiber cable, the rubber cover should be replaced to protect the optics . inside the device.

2.Check that the fiber terminators are clean. You can clean the cable plugs by wiping them gently with a clean tissue or cotton ball moistened with a little ethanol. Dirty fiber terminators on fiber optic cables will impair the quality of the light transmitted through the cable and lead to degraded performance on the port.

3.Connect one end of the cable to the SC/WDM port on the converter and the other end to the SC/WDM port on the other device. NOTE: When inserting the cable, be sure the tab on the plug clicks into position to ensure it’s properly seated.

4.Check the corresponding port LED on the converter to make sure the connection is valid.

Connecting Copper Cable

The 1000Base-T RJ-45 Ethernet port fully supports auto-sensing and auto- negotiation. Follow the steps below to properly connect fiber cable.

1.Insert one end of a Category 5 twisted pair cable into the RJ-45 port . on the converter and the other end into the port of the network node.

2.Check the corresponding port LED on the converter to make sure the connection is valid.

Cable Installation Tips

Cables can affect network performance if not installed or positioned properly. To help ensure your equipment operates at optimal levels:

• Try to maintain a bend radius that’s a minimum of 4x the diameter of .