■ BEFORE YOU BEGIN ... ■
Daily handling
Before using the equipment, make sure you and your
PAY ATTENTION TO THESE WARNINGS! FAILURE
TO FOLLOW THESE WARNINGS COULD RESULT
IN INJURY FROM FIRE OR ELECTRICAL SHOCK!
WARNING
■Always observe these warnings when using the scanner. Failure to follow these warnings could result in injury due to fire or elec- tric shock.
■Do not set up the scanner in a location close to flammable sol- vents such as alcohol and paint thinners.
■Do not cut, damage or modify the power cord, do not pull or bend the power cord excessively, and do not place heavy objects on the power cord.
■Never plug in or unplug the power cord with wet hands.
■Do not place objects on top of the scanner as such objects could fall and cause injury. Do not plug the scanner into a
■Do not knot or bundle the power cord, and ensure that the plug is pushed fully into the power outlet.
■Use only the power cord supplied with the scanner.
■Do not attempt to disassemble or modify the scanner. There are no
■Do not use flammable sprays or aerosols near the scanner.
■Switch the scanner off and unplug the power cord before cleaning the scanner.
■To clean the unit, use a cloth lightly dampened with water or a mild detergent.
■If the scanner emits an unusual noise, odor, smoke or sparks, or if the scanner will not function when switched on, immediately switch the scanner off, unplug the power cord and contact an au- thorized Canon dealer or service center.
■Before you move the scanner even a short distance, switch the scanner off and unplug the power cord.
CAUTIONS
■Do not set up the scanner on sloping, wobbly or otherwise un- stable surfaces or in locations affected by excessive vibration. The scanner could cause injury if it falls over or slides off the surface.
■Do not block the ventilation slots as this could result in a fire due to the build up of heat inside the scanner.
■Do not place vessels containing liquids (cups, vases, etc.) or small metal objects (paper clips, staples, necklaces, etc.) on top of the scanner. Liquids or metal objects falling into the scanner could cause an electric shock or fire. If any liquids or metal objects fall into the scanner, immediately switch the scanner off, unplug the power cord and contact an authorized Canon dealer or service center.
■Do not set up the scanner in dusty or humid locations as this could result in an electric shock or fire.
■Do not place heavy objects on top of the scanner as such objects could fall and cause injury.
8
8 | 07.5.14, 14:19 |