OPERATION (CONTINUED)
SETTING THE FREQUENCY MODE
Because the electrical power frequency is either 50Hz or 60Hz, depending on the country you are located in, please set it according to the country that you are located in. If located in USA, set to 60Hz.
12
Turn the camera on as described on page 8. Press the Mode/Power button eight times to select the Frequency mode; “60” or “50” will appear in the display.
RESET BUTTON
1
To restore the camera to the factory defaults, press the RESET button (inside compartment) using a pin or similar item.
Within 3 seconds, press the Shutter/Select button to select the Frequency mode as shown on the display i.e. if 60 appears, press the Shutter/Select button to change the setting to 60.
DISPLAY
The display can only display two digits. Although the capacity for pictures in Lo(w) Resolution is 100, the display will show 99 until two pictures have been taken and then change to 98.
RESET BUTTON NOTE: When you press the RESET button, all the taken photos in the camera will be deleted.
13