General Information
= Copyrights =
All rights reserved. The information contained in this user’s manual is subject to change without notice. HiTi Digital Inc. makes no warranty with regard to the material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. HiTi Digital Inc. will not liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of the material.
= Safety Precautions =
1.Never attempt to disassemble for modify the printer. Doing so may lead to electric shock or malfunction.
2.Do not allow liquids near the printer, which may lead to electric shock or fire.
3.Do not use the printer if the printer body is damaged.
4.Avoid plugging in the printer into a jack being used by couple appliances.
5.Do not put the printer on an unstable cart, stand, or table.
6.Make sure the printer is operated under the type of power indicated on the marking label. If you are not sure the type of power, please consult your dealer or local power company for detail.
7.Do not block air vents protecting the printer from overheating.
8.Do not disable the safety purpose of grounding type plug. Use the power supply cord only in combination with an earthed
9.The
10.The equipment shall be used at maximum 40°C ambient temperature.
11.An approved power cord greater or equal (e.g.
= FCC Notice =
Do not make any changes or modifications to the equipment unless specified in the instruction. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Never push objects into this equipment through cabinet openings, which may touch dangerous voltage points or short out parts that could lead to a fire or electric shock.
4.Never spill liquid on this equipment.
5.Connect the device into an outlet on a circuit difference from that to which the receiver is connected.
2