Canon ZR20 Audio Dubbing, To connect other audio equipment, To connect an external microphone

E

Audio Dubbing

You can add sound to the original sound on a pre-recorded tape from audio products (AUDIO IN) or with the internal or external microphone (MIC. IN). The original sound will not be erased. For best results, add sound to tapes that have been recorded with this camcorder in SP mode with 12-bit sound. If there are non-recorded portions on the tape, or portions recorded in a mode other than SP mode, or with 16-bit or 12-bit, 4-channel sound, dubbing will stop. If your tape hasn’t been recorded in SP mode with 12-bit sound, we recommend dubbing your original tape onto a blank tape using the ZR20’s analog line-in function, then dubbing audio onto the new tape. Make absolutely sure to set the audio mode of the new tape to 12-bit and the recording mode to SP.

To connect other audio equipment:

STV-250N Stereo Video Cable

AV

IN/OUT

: Signal flow

OUTPUT

AUDIO

L	An audio device
R	(i. e. CD player)

MIC

Editing

•Make sure the AV/headphone terminal is set to AV through the menu ( 30). If PHONES appears in the display, switch the terminal.

Notes:

•Do not use the yellow video terminal.

•The AV terminal doesn’t put out any video, so connect the S-video terminals and check your TV, or check the LCD or the viewfinder as you add new sound. Always check the new sound with the speaker.

To connect an external microphone:

82