Installation of the trim set, Trouble shooting

Installation of the trim set

Z.532.545

Z.632.096

Z.532.547

Z.532.544	Z.532.642

Z.632.029

*Z.532.543

Z.532.641

*Z.505.179

*Z.532.549

(extended length 155mm / 6 1/8")

E * Please specify the color when placing your order.

Malfunction:	Cause:	Remedy:
Hot and cold reversed	Hot and cold water supplies have been connected in	Rotate cartridge as described in "Back-to-back
	reverse.	installation".

Tub filler shower head drips after shutting off the	Water remains in the shower piping.	Allow approximately 3 - 5 minutes to drain column, or
valve.	(This is normal)	push lever on tub spout to the tub fill position * .
	Incorrect setting of the stop ring causing a partially	Reset the hot limit stop ring as described in rough-in
	opened cartridge.	installation.
	Cartridge inlet O-ring seal is faulty.	Check the O-ring for cuts or damage and replace if
		necessary.

Shower insufficiently hot	Hot limit stop incorrectly set.	Refer to the instruction: Check hot water temperature.

No flow of hot or cold water	Either the hot or cold side is not fully pressurized.	Be sure service stops are both fully open and system
	Debris caught inside the inlet of the cartridge.	is pressurized.
	No engagement between escutcheon and plastic	Remove cartridge and flush out or remove any debris
	driver.	lodged inside the hot or cold inlets.
		Install either the 1/2" or 3/4" extension kit.

Valve body too deep in wall	Improper installation.	Install either the 1/2" or 3/4" extension kit.

!Never try to stop dripping by applying excessive force to the handle when closing the valve!