Sony CCD-TR98, CCD-TR78, CCD-TR88 operation manual Tips for Using the Battery Pack

Page 35

Tips for Using the Battery Pack

When the remaining battery indicator reaches the lowest point, the i indicator appears and starts flashing in the viewfinder.

When the iindicator in the viewfinder disappears and the battery lamp flashes rapidly, turn the POWER switch to OFF on the camcorder and replace the battery pack. Leave the tape in the camcorder to obtain smooth transition between scenes after the battery pack has been replaced.

Note on the remaining battery indicator

The remaining battery indicator of the camcorder may indicate a different remaining capacity from that of the battery pack with the remaining battery indicator (not supplied). The indicator of the battery pack is more accurate.

Notes on the Rechargeable Battery Pack

Caution

Never leave the battery pack in temperatures above 140°F (60°C), such as in a car parked in the sun or under direct sunlight.

The Battery Heats Up

During charging or recording, the battery pack heats up. This is caused by energy that has been generated and a chemical change that has occurred inside the battery pack. This is not cause for concern and is normal.

Battery Pack Care

•Remove the battery pack from the camcorder after using it, and keep it in a cool place. When the battery pack is installed to the camcorder, a small amount of current flows to the camcorder even if the POWER switch is set to OFF. This is shortens battery life.

•The battery pack is always discharging even when it is not in use after charging. Therefore, you should charge the battery right before using the camcorder.

How to Use the Switch on the Battery Pack

When the switch is supplied with the battry pack ([a] on p. 36) you can use it to find whether the battery pack is charged or not. Set the switch to the “no mark” position when charging is completed. Set the switch to the “red mark” position when the battery is used up (or in whichever direction you want to remind yourself).

The Life of the Battery Pack

If the battery lamp flashes rapidly just after turning on the camcordrer with a fully charged battery pack, the battery pack should be replaced with a new fully charged one.

Charging Temperature

You should charge batteries at temperatures from 50°F to 86°F (from 10°C to 30°C). Lower temperatures require a longer charging time.

Sony Batteries are Recommended

Use of non-Sony batteries may damage your Handycam camcorder.

Playback Modes/Tips for Using the Battery Pack

35

CCD-TR78/TR88/TR98 3-810-917-13.E

Page 34 Page 36
Image 35
Page 34 Page 36
Contents
Video Camera Recorder h Welcome to video h For the Customers in the U.S.ATable of Contents Before You Begin Using This ManualPrecaution on Copyright Precautions on Camcorder CareChecking Supplied Accessories Charging Time Charging and Installing the Battery PackCharging the Battery Pack Getting StartedTo Remove the Battery Pack Battery LifeInstalling the Battery Pack Charging and Installing the Battery PackTo Prevent Accidental Erasure Inserting a CassetteTo Eject the Cassette To Finish Recording b Camera RecordingBasic Operations To Stop Recording Momentarily aShooting scenery in several short takes To Focus the Viewfinder LensCCD-TR78/TR88 CCD-TR98 Recording with the START/STOP button depressedCamera Recording When moving from indoors to outdoors or vice versaZooming Speed Using the Zoom FeatureWhen you shoot a subject using a telephoto zoom Place the camcorder on a flat surface or use a tripod Hints for Better ShootingTo Begin Re-recording Checking the Recorded PictureTo Connect a TV or a VCR without Video/Audio Input Jacks Connecting Directly to a TVConnections for Playback If a VCR is connected to a TVPlaying Back a Tape To locate a scene Picture Search Playing Back a TapeVarious Playback Modes To view a still picture playback pauseAdvanced Operations Using Alternative Power SourcesUsing the House Current Model Typical recording time Continuous recording time Using Alternative Power SourcesUsing the Battery Case To remove the adaptorTo Stop Recording with the Date or Time Using a Car BatteryTo remove the battery case Recording with the Date or TimeTo Turn On the Built-in Light Automatically Using the Built-in LightReplacing the Bulb ŒSports mode Twilight mode Using the Program AE FunctionSelecting the Best Mode Using the Program AE FunctionThis function is also effective under following conditions Shooting with BacklightingAfter Shooting To Extend the Recording Time in 5 SEC Mode Selecting the START/STOP ModeTo Superimpose On the Way of Recording Superimposing a TitleTo Superimpose from the Beginning CCD-TR88/TR98 only Using the Steady Shot FunctionUsing the Steady Shot Function To Release the Steady ShotZoom x24/x12 Changing the Mode SettingsSelecting the Mode Setting of Each Item To Stop Editing Editing onto Another TapeTo Edit More Scenes Additional Information Changing the Lithium Battery in the CamcorderChanging the Lithium Battery Changing the Lithium Battery in the CamcorderTo Check the Date and Time Resetting the Date and TimeTo Correct the Date and Time Setting Year indicator changes as followsPlayback Modes Tips for Using the Battery PackPreparing the Battery Pack When to Replace the BatteryTips for Using the Battery Pack Be Sure to Observe the Following Brand-new BatteryAfter Long Storage If battery leakage occurred Inside the Camcorder Maintenance Information and PrecautionsHow to Prevent Moisture Condensation Moisture CondensationVideo Head Cleaning CCD-TR78/TR88 only Maintenance Information and PrecautionsRemoving Dust from inside the Viewfinder To Reattach the EyecupPrecautions Difference in Color Systems Using Your Camcorder AbroadPower Sources Camcorder PowerSymptom Cause and/or Corrective Actions Trouble CheckOthers Trouble CheckPicture When the Charge lamp AC Power AdaptorWhen the Charge Lamp Flashes Video Camera Recorder SpecificationsOutput voltage Applicable battery Sony battery pack Ni-Cd typeStorage temperature -4F to +140F -20C to +60C Dimensions Identifying the Parts @¥ Tripod receptacle p Viewfinder adjustment ring p @£ VIDEO/AUDIO jacks p@¼ Grip strap p @» Tape transport buttons p Identifying the PartsTransmitter Remote CommanderAttaching the shoulder strap To avoid damage from possible battery leakage Preparing the Remote CommanderUsing the Remote Commander To Watch the Demonstration Remote Control DirectionTo enter Demo mode To exit Demo modeOperation Indicators Battery Remaining V, W, X, Y K, LO, P
Related manuals
Manual 54 pages 43.93 Kb