2.4.2 Disassembly/assembly
1. A Cassette housing assembly
<STOP mode>
Note 1a:
Shift the mechanism mode from the STOP mode to the EJECT mode.
1(L1b)
(S1)
2
(S1)
(L1b)
Cassette
Ahousing assembly
(L1a)
3 (S1)
Note 1b
<EJECT mode> |
Note 1b:
Reassemble the cassette housing assembly to the mechanism as the cancel lever is moved in the direc- tion of the arrow.
Note 1c:
When reassembling the cassette housing to the mechanism, make sure that there is no deformation in the frame or no damage to the switches, etc.
Note 1d:
(L1d) | (L1a) |
| |
(L1c) | Slide deck assembly |
| /Main deck assembly |
| Note 1c |
Fig.
2.2a Reel disk (SUP) assembly
2b Reel disk (TU) assembly
2c Reel cover assembly
<PLAY mode> |
After reassembling the com- ponent parts, check the mechanism operation in the PLAY mode.
For details of checking method, refer to “2.6.1 as- sembling slide deck assem- bly and main deck assem- bly”.
(W2)
Note 2a:
When removing the reel disk assembly, be careful not to
Note 2b
(W2)
break the brake pad which applies lateral pressure to the reel disk.
2a |
| 2b | |
|
| ||
4 | 6 | Note 2b | |
(S2a) | (S2b) | ||
|
5
(S2a)
(W2)
2c
Note 2c
Note 2a
Note 2c
Slide deck assembly
/Main deck assembly
Note 2a
Fig.
Note 2b:
Be careful not to make a mistake in installing the reel disk. The SUP reel disk and TU reel disk can be distinguished from each other by the appearance as shown below.
(SUP)(TU)
Note 2c:
When reassembling the cassette housing to the mechanism, make sure that there is no deformation in the frame or no damage to the switches, etc.
Note 2d:
When fitting the reel cover assembly to the set, carefully tighten the screw with the specified tightening torque of 0.069N • m (0.7kgf • cm).