CDX-CA850/CA850X/CA860X, Service Notes | Sony Ericsson CDX-CA850X

CDX-CA850/CA850X/CA860X

Dimensions	Approx. 178 ⋅	50 ⋅ 177 mm
	(7 1/8 ⋅ 2 ⋅ 7 in.) (w/h/d)
Mounting dimensions	Approx. 182 ⋅	53 ⋅ 162 mm
	(7 1/4 ⋅ 2 1/8 ⋅	6 1/2 in.) (w/h/d)
Mass	Approx. 1.3 kg
	(2 lb. 10 oz.)
Supplied accessories	Parts for installation and connections (1 set)
	Front panel case (1)
	Rotary commander

RM-X5S

Card remote commander

RM-X112 (CDX-CA850X/CA860X)

RM-X113 (CDX-CA850)

Note

This unit cannot be connected to a digital preamplifier or an equalizer.

Design and specifications are subject to change without notice.

SERVICE NOTES

• US, Canadian model

• AEP, UK model

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

If the optical pick-up block is defective, please replace the whole optical pick-up block.

Never turn the semi-fixed resistor located at the side of optical pick-up block.

optical pick-up block

semi-fixed resistor

NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK OR BASE UNIT

The laser diode in the optical pick-up block may suffer electrostatic breakdown because of the potential difference generated by the charged electrostatic load, etc. on clothing and the human body.

During repair, pay attention to electrostatic breakdown and also use the procedure in the printed matter which is included in the repair parts.

The flexible board is easily damaged and should be handled with care.

SAFETY-RELATED COMPONENT WARNING!!

COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN

THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.

This label is located on the bottom of the chassis.

This label is located on the drive unit's internal chassis.

When replacing the chassis (T.U) of mechanism deck which have the “CAUTION LABEL” attached, please be sure to put a new CAUTION LABEL (3-223-913-11) to the chassis (T.U).

NOTES ON LASER DIODE EMISSION CHECK

The laser beam on this model is concentrated so as to be focused on the disc reflective surface by the objective lens in the optical pick- up block. Therefore, when checking the laser diode emission, ob- serve from more than 30 cm away from the objective lens.

Notes on Chip Component Replacement

•Never reuse a disconnected chip component.

•Notice that the minus side of a tantalum capacitor may be dam- aged by heat.

ATTENTION AU COMPOSANT AYANT RAPPORT

À LA SÉCURITÉ!!

LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES

DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.