1 Introduction
Thank you for purchasing the camera. Before installing it, please verify your model and read this guide carefully. See the INSTRUCTIONS located on
Unpack Everything
∙HD IP CAMERA
∙WARRANTY CARD
∙SAFETY PRECAUTIONS
∙QUICK GUIDE
∙
∙
Prepare for Installation
Select the lens to use with your camera. This camera supports the use of a manual iris or DC iris lens . When using a DC iris lens, it should be connected to the camera via the
Mount the Camera
1. Attach the camera to a pending mount.
Insert the screws on the camera stand into either of the screw holes on the base. Then tighten them up.
2.Mount the camera onto the ceiling/wall and fasten it securely.
3.Connect the Safety Wire(Fall Prevention Wire, not supplied) to the camera and the wall/ceiling.
Warning
To prevent the camera from falling off, ensure that it is connected to a firm place
(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not
supplied).
Pay also careful attention to the length, strength, wiring, and material (insulating
properties) of a Safety Wire (fall prevention wire) to be used. The length should
be as short as possible within the permissible range of the mounting length. The
wire should be strong enough to withstand the total weight of this product and the
fixer. (Pay also attention to the finishing at the end of the wire.)
Must be isolated camera and the wall/ceiling which are connected by a Safety
Caution
Wire (Fall Prevention Wire).
2