JVC GR-DVL220 12 EN, Loading/Unloading a Cassette, Approximate recording time Tape Recording mode

Page 12

12 EN

GETTING STARTED (cont.)

Erase protection tab*

Make sure the window side is facing out.

Cassette holder

OPEN/EJECT

Switch

Cassette holder cover

PUSH HERE

* To Protect Valuable Recordings . . .

.... slide the erase protection tab on the back of the

tape in the direction of “SAVE”. This prevents the tape from being recorded over. To record on this tape, slide the tab back to “REC” before loading it.

Be sure to press only the section labeled “PUSH HERE” to close the cassette holder; touching other parts may cause your finger to get caught in the cassette holder, resulting in injury or product damage.

Loading/Unloading A Cassette

The camcorder needs to be powered up to load or eject a cassette.

1 Slide and hold OPEN/EJECT in the direction of the arrow then pull the cassette holder cover open until it locks. The cassette holder opens automatically.

• Do not touch internal components.

2 Insert or remove a tape and press “PUSH HERE” to close the cassette holder.

•Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.

•When the battery’s charge is low, you may not be able to close the cassette holder cover. Do not apply force. Replace the battery with a fully charged one before continuing.

3 Close the cassette holder cover firmly until it locks into place.

Approximate recording time

Tape

Recording mode

 

 

SP

LP

 

 

 

 

30 min.

30 min.

45 min.

 

 

 

60 min.

60 min.

90 min.

 

 

 

80 min.

80 min.

120 min.

 

 

 

NOTES:

●It takes a few seconds for the cassette holder to open. Do not apply force.

●If you wait a few seconds and the cassette holder does not open, close the cassette holder cover and try again. If the cassette holder still does not open, turn the camcorder off then on again.

●If the tape does not load properly, open the cassette holder cover fully and remove the cassette. A few minutes later, insert it again.

●When the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before opening the cassette holder cover.

●Closing the cassette holder cover before the cassette holder comes out may cause damage to the camcorder.

●Even when the camcorder is switched off, a cassette can be loaded or unloaded. After the cassette holder is closed with the camcorder switched off, however, it may not recede. It is recommended to turn the power on before loading or unloading.

●When resuming recording, once you open the cassette holder cover a blank portion will be recorded on the tape or a previously recorded scene will be erased (recorded over) regardless of whether the cassette holder came out or not. See page 18 for information about recording from the middle of a tape.

●Loosen the Grip Strap if it appears to interfere with the cassette holder cover operation ( pg. 10).

Page 11 Page 13
Image 12
Page 11 Page 13
Contents GR-DVL220 Dear Customer It is recommended that youImportant Product Safety Instructions Before recording an important scene Provided Accessories Automatic Demonstration takes place when Demo Mode is set to on factory-presetHow To Attach The Lens Cap Lock ButtonGetting Started Power Charging the Battery PackBattery pack Charging time To Detach The Battery PackUsing the Battery Pack Using AC PowerAbout Batteries Approximate recording timeGrip Adjustment Viewfinder Adjustment10 EN Shoulder Strap AttachmentDate/Time Settings Set the Power Switch toMENU/BRIGHT Wheel Power Lamp Lock Button DisplayApproximate recording time Tape Recording mode 12 ENLoading/Unloading a Cassette Recording Mode Setting Set the tape recording mode depending on your preferenceMenu Screen Sub Menu14 EN Remove the lens cap Set the Power Switch to To Adjust The Brightness Of The DisplayBasic Recording To Stop RecordingOperation Mode Power Switch Position16 EN Journalistic ShootingSlide the Power Zoom Lever towards T ZoomZoom Out Zoom in T TelephotoWhen a blank portion is recorded on a tape 18 ENTime Code Proper recordingTo Control The Speaker Volume Normal PlaybackSpeaker 20 EN ConnectionsIf using a VCR . . . go to step If not . . . go to step To cancel Blank Search midway 22 ENBlank Search PressAdvanced Features To Deactivate The Selected Mode 24 ENNight-Alive Program AE With Special EffectsShutter SnowSpotlight TwilightPower Switch Recording Start/Stop Button 26 ENFade/Wipe Effects To Deactivate The Selected EffectFader And Wipe Menu Snapshot Mode Selection 28 ENSnapshot Snapshot RecordingWhile focusing on a nearer subject To obtain correct focusFocus detection zone Subject30 EN Exposure ControlIris Lock White Balance Adjustment Manual White Balance OperationCloud Halogen32 EN For Recording MenuWIPE/FADER Program AEMenu Screen Explanations Manual System Tele OFF MacroWide OFF CinemaCAM Cancel Reset ExecuteSystem Display Demo OFF LCDFollowing procedure applies to all except Synchro Comp  pg 36 ENFor Playback Menu Playback Sound DisplayConnector cover Power Switch To AV 38 ENDubbing To a VCR Engage the VCR’s AUX and Record-Pause modesTo use this camcorder as a player To DVCore filter DV cable optional Remote control uses one lithium battery CR2025 40 ENLock hole Knob Remote sensorWith the camcorder’s Power Switch Switch set to the camera Set to PlayRM-V715U Provided 42 EN Time during playbackTo magnify the recorded image up to 70X at any Zoom ButtonsSET REMOTE/VCR Code You are now ready to try Random Assemble EditingVCR Recording deck RM-V700U optionalConnect the editing cable to the Remote Pause connector Connect the editing cable to the R.A.EDIT Connector44 EN Make ConnectionsSelect Scenes Editing Menu46 EN Automatic Editing to VCRAdjustment of VCR/CAMCORDER Timing For More Accurate EditingDiagnosing VCR/CAMCORDER Timing ProgramSet 12BIT Mode to Sound 2 or MIX Menu Screen  pg 48 ENAudio Dubbing To hear the dubbed sound during playbackInsert Editing Using PC connection cable Using DV cable50 EN References 95F C to 25C 68F to 77F is the ideal temperature range for 52 ENTroubleshooting Used  pgActivated Setting White Balance  pg 54 ENColor of Snapshot looks Find a white subject and composeWhen shooting a subject Set Time Code to onNearest JVC dealer Rear of the LCD monitor 56 EN Repeat the above two or three Times, please consult your nearestJVC dealer  pg this can be avoidedCleaning The Camcorder 58 ENAfter Use Using Household AC Plug Adapter 60 EN About moisture condensation Serious malfunctioningDeclaration of Conformity Model Number Trade Name62 EN Appears when the Power Switch is set to  pg Appears when Night-Alive is engagedBR I GHT JAN 1Volume 64 ENLCD Monitor/Viewfinder Indications During Playback Index IndicationsE01, E02 or E06 E03 or E04Index Controls, Connectors And Indicators 66 ENPower Switch DC Input ConnectorDigital Video Connector Control +Terms

GR-DVL220 specifications

The JVC GR-DVL220 is a versatile and compact digital camcorder that has been designed to cater to both novice filmmakers and seasoned videography enthusiasts. This model, part of JVC's GR-DV line, stands out for its user-friendly features, advanced technologies, and exceptional performance in a portable form factor.

One of the primary highlights of the GR-DVL220 is its impressive image quality, which is powered by a 1/4-inch 680,000-pixel CCD sensor. This allows users to capture vibrant and clear videos in resolutions up to 720x480 pixels, making it suitable for various applications, from home videos to more professional projects. The camcorder also boasts a 10x optical zoom, complemented by a 120x digital zoom, providing great flexibility for framing shots from a distance without compromising much on quality.

The lens of the GR-DVL220 features a f/1.6 aperture, which plays a pivotal role in low-light performance, enabling users to shoot impressive footage even in less-than-ideal lighting conditions. Additionally, the camcorder is equipped with JVC's proprietary Digital Image Stabilization (DIS) technology, which minimizes the unwanted shake and jitter that can occur during handheld shooting. This results in smoother footage, contributing to a more professional final product.

Another notable characteristic is the built-in firewire (IEEE 1394) connectivity, which allows for high-speed data transfer between the camcorder and other digital devices. This feature is essential for video editing, as it enables seamless uploads to a computer for further enhancement. The GR-DVL220 is also compatible with a variety of video formats, including DV and MPEG-1, ensuring that users can choose the best option for their needs.

The camcorder comes with a 2.5-inch color LCD screen that provides a clear view for composing shots and navigating menus. With easy-to-use controls, the GR-DVL220 ensures that users can quickly adapt to its functionalities. Additionally, it includes various scene modes and digital effects, allowing for creative storytelling through video.

Powering the GR-DVL220 is a rechargeable lithium-ion battery, which provides a decent amount of recording time, suitable for most shooting sessions. The compact design makes it easy to carry around, making it a great companion for travel and outdoor shoots.

In conclusion, the JVC GR-DVL220 is a well-rounded digital camcorder that combines user-friendly features with advanced technologies, offering great image quality, flexibility, and convenience for both amateur and professional users. Whether capturing special family moments or creating cinematic projects, this model provides a reliable option to meet diverse filming needs.
Top Page Image Contents