JVC GR-SXM72ED, GR-SX52ED, GR-SX51A, GR-SXM81A, GR-SXM75ED, GR-SXM82ED 42 EN, Insert Editing

Set the Power Switch to “PLAY”.

Play back the tape, locate the Edit-Out point and press PAUSE (6).

42 EN USING THE REMOTE CONTROL UNIT (cont.)

Power Switch

COUNTER R/M Button

Display

w

	Insert editing
	indicator
M– 0 : 1 2 : 3 4	Tape Counter

Remote sensor

START/STOP

REW

INSERT

PLAY

STOP

PAUSE

RM-V716U	OR	RM-V715U
(provided with		(provided with
GR-SXM91A/		GR-SXM71A/
SXM81A/SX51A/		SXM61A/
SXM92ED/		SXM75ED/
SXM82ED/		SXM72ED/
SX52ED only)		SXM62ED only)

Insert Editing

You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the remote control unit to perform this procedure.

1

2

3 Press and hold COUNTER R/M on the camcorder for more than 1 second to reset the tape counter, then press it again for less than 1 second so that “M” appears.

4 Press REW (2) to go a little beyond the beginning of

the scene you want to replace, press PLAY (4) to view the recorded tape, and press PAUSE (6) exactly at the Edit-In point where the new scene should start.

5 Press and hold INSERT (w), and without releasing INSERT (w), press and release PAUSE (6). The Insert Editing indicator appears and the Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

6 To begin Insert Editing, press START/STOP. When the counter reaches “0:00:00”, editing stops automati- cally and the camcorder enters the Insert-Pause mode.

7 To end Insert Editing, press STOP (5).

NOTES:

●During Insert Editing, the original audio will be heard from the speaker.

●After step 5, Retake (
pg. 19) can be performed.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only the video signal is recorded in the Insert Editing mode.

●If Programme AE (
pg. 23) is set during Insert Editing, press and hold P. AE for more than 1 second.