JVC GZ-MG70EK manual Operation Mode, Data Battery System, Using AC Power, About Batteries

Page 16

MasterPage: Body_Left M5E6PAL.book Page 16 Friday, August 26, 2005 8:16 PM

16 EN GETTING STARTED

 

 

 

Data Battery System

Operation Mode

You can check the remaining battery power and

To turn on the camera, set the power switch to

the recordable time.

1 Make sure the battery is attached.

or

while pressing down the lock button

located on the switch.

2 Open the LCD monitor fully.

● The power/charge lamp turns on.

3 Press INFO/ repeatedly, and the battery

To turn off the camera, set the power switch to

status screen appears.

OFF.

 

 

 

 

 

● It is displayed for approx. 3 seconds if the

1 Power Switch

 

button is pressed and released quickly, and for

 

 

 

 

approx. 15 seconds if the button is pressed

 

 

Power/Charge Lamp

and held for several seconds.

 

 

 

● If “COMMUNICATING ERROR” appears

 

 

 

instead of the battery status even though you

 

 

 

tried to press INFO/ several times, there

 

 

 

may be a problem with your battery. In such a

 

 

 

case, consult your nearest JVC dealer.

 

2 MODE

 

● The recordable time display should only be

 

Lock Button

used as a guide. It is displayed in 10 minute

4 LCD Monitor

units.

3

Using AC Power

Perform step 4 in “Charging the Battery Pack” ( pg. 14).

NOTE:

Set the appropriate operation mode according to your preference using the power and MODE switches and (/) button.

The provided AC adapter features automatic voltage 1 Power Switch Position selection in the AC range from 110 V to 240 V.

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

To resume the original function of the accurate battery power indication

If the battery power indication differs from the actual operating time, fully charge the battery, and then run it down. However this function may not work properly if the battery was used for a long period of time under extremely high/low temperature condition or charged too many times.

Set the power switch for recording () or playback () while pressing down the lock button.

Power Switch

Power Off

Playback

Recording

Page 15 Page 17
Image 16
Page 15 Page 17
Contents
To deactivate the demonstration, set Demo Mode to OFF.  pg GZ-MG70E/EKBuilt-in Hard Disk Various Recording ModesEditing Files on your PC FlashContents Dear Customer Blue to N Neutral or Black Brown to L Live or RedInformation for Users on Disposal of Old Equipment European UnionBefore Using this Camera Above ALLGetting Started EN Provided AccessoriesLens Cap See page 8 for attachment Getting Started Attaching the Shoulder StrapAttaching the Lens Cap Eyelet Place here during recording Buckle Strap GuideAttaching the Core Filter Video/Audio/Video/USB cableDC cord Close the core filter until it clicks shutIndex EN Getting StartedIndicators ConnectorsControls Other Parts  pg Shooting Icon  pg Self-Timer Recording Indicator  pg Indications on LCD Monitor During Video Recording only During Still Image Recording onlyDuring Video Playback During Still Image Playback Charging the Battery Pack PowerRequired charging time Perform steps 2 3 in Charging the Battery Pack  pg Using the Battery PackMaximum continuous recording time Operation Mode Data Battery SystemUsing AC Power About BatteriesPower-Linked Operation Recording/Playback ModeLanguage Setting Built-in Clock’s Rechargeable Lithium Battery Date/Time Settings Brightness AdjustmentDisplay Grip Adjustment Tripod MountingInserting/Removing an SD Card Media to work with this cameraTo make it more Difficult to recover Data on the hard disk Formatting a Recording MediumRemaining Space on the Recording Media Drop DetectionSelecting a Recording Medium Video Recording EN Video Recording & PlaybackPress the recording start/stop button to start recording To stop recording, press Recording start/stop button againZooming Deleting FilesTo zoom To zoom outTo adjust the speaker volume Video PlaybackTo play back files in the Extmov folder To return to the index screenVideo Recording & Playback EN Connecting to a TV, VCR or Playback on a TVDubbing to a VCR or DVD Recorder DVD RecorderInstalling the Battery Playback Using the Remote Control Buttons and FunctionsBeam Effective Area Still Image Recording EN Still Image Recording & PlaybackContinuous Shooting Recording Start/Stop ButtonStill Image Playback Still Image Recording & Playback ENSlide Show Index Screen of Still Image FilesPlayback Zoom Date Index Screen Deleting Still Image FilesTo cancel backlight compensation To cancel spot exposure controlWhen not using the flash Spot Exposure ControlManual Settings in Mset EN Recording FeaturesManual Exposure Menu Recording Features EN Manual FocusTo return to automatic focus Manual focus is recommended in situations listed belowCloud When shooting outdoors on a Halogen When a video light or similarType of lighting is used Press To close the Mset menuTo change the shutter speed Shutter SpeedTo return to automatic shutter speed Program AE To turn off the program AE functionTo turn off the effect Select OFF in stepPlayback Features EN Wipe or Fader Effects Playback EffectsEN Managing Files Information on Video FilesProtecting Files Information on Still Image FilesButton Deleting FilesDeleting on the Menu Screen Cleaning Up a Recording MediumTo delete by selecting multiple files To delete all filesTo copy or move by selecting files FilesBefore proceeding to following steps Resetting the File Number Creating Play ListTo check the play list by playing back VideoTo check only the scene transition To delete the added file from the play listAdd/Delete Files in Play List Changing Play List Name Managing Files EN Deleting Play ListDpof Print Setting To confirm the Dpof settingTo reset the Dpof setting To print all still images One print for eachTo cancel print setting To print using the Dpof settingPrinter Direct Printing with a PictBridgeEN Menu Settings Select the operation modeCommon Menus for All Modes For Recording MenusMenu Settings EN HDD / SDVideo Playback Menus Video Recording MenusStill Image Playback Menus 1600 x 1200 / 1280 x 960 / 1024 x 640 xOFF / 2SEC / 10SEC Auto / 80Troubleshooting PowerEN References RecordingReferences EN Advanced featuresPlayback Other problems Battery indicator Appears when no SD card is inserted in the SD slot.  pgLock position.  pg Attempt still image playbackOperation is not available in the video mode Recording FailureCleaning the Camera Battery PacksRecording Medium LCD MonitorMain Unit How to Handle a CD-ROM Specifications CameraFormat Power requirement Battery lifeOperating temperature WeightCompatible recording media SD cardApproximate recording time for video 128 256 512Approximate number of storable images for still image Terms 42 45
Top Page Image Contents