9
NOTES:
●The recording time per charge is affected by such factors as the time spent in Record/Standby mode and the frequency of zooming. It is safer to have spare battery packs.
●Charging times noted on page 8 are for fully discharged battey pack, and discharging times are for fully charged battery pack.
●Charging and discharging times vary according to the ambient temperature and the status of the battery pack.
●Remember to set the charge marker after charging a battery pack or after detaching a discharged one from your camcorder.
●Perform the REFRESH function after no less than 5 chargings.
●High temperatures can damage the battery pack, so use only where good ventilation is available. Don’t allow it to discharge in container, such as a bag.
●If you stop recharging or discharging part way through, make sure to remove the battery pack before unplugging the adapter’s AC cord.
●Remove the battery pack from the adapter immediately after discharging.
●To avoid interference with reception, do not use the AC Power Adapter/Charger near a radio.
●Make sure you unplug the DC cord before charging or discharging the battery pack.
●A blinking CHG. indicator means that the battery pack has become hot. Wait until it cools down to continue.
●The CHG. indicator may not light properly with a brand new battery pack, or with one that’s been stored for an extended period. In this case, remove and reattach the battery pack and recharge it. The CHG. indicator should light during recharging. If not, contact your nearest JVC dealer.
To AC outlet
DC OUT
terminal
To DC in jack
AC Power
Adapter/Charger
DC cord
To car’s cigarette lighter
Car Battery Cord socket AP-V7U (optional)
USING A CAR BATTERY
Use the optional Car Battery Cord or Car Battery Charger/Adapter (connect as shown in the illustration to the left).
NOTES:
●When using the car battery, leave the engine idling.
●The optional Car Battery Charger
●When using the optional Car Battery Charger or Car Battery Cord
USING AC POWER
Use the AC Power Adapter (connect as shown in the illustration to the left).
Car Battery Charger/Adapter
BH-V3U (optional)
NOTES:
●You can attach the battery case to the camcorder in the same way as a battery pack (☞ pg. 8).
●Recording time varies depending on the type of alkaline batteries you use.
●When the battery remaining power becomes low, noise may appear in the picture or become audible in the sound. When this happens, use another power source or replace with new alkaline batteries.
●Also read thoroughly the
NOTE:
The supplied AC Power Adapter/Charger features automatic voltage selection in the AC range from 110 V to 240 V.
USING DRY CELL BATTERIES
The optional Battery Case
It enables you to continue using the camcorder even if you run out of charged battery packs.