JVC LYT0242-001A Do not leave the unit, To protect the unit, do not, About moisture condensation

Page 68

68ENCAUTIONS

(cont.)

3.DO NOT leave the unit . . .

... in places of over 50°C (122°F).

... in places where humidity is extremely low. (below 35%) or extremely high (above 80%).

... in direct sunlight.

... in a closed car in summer.

... near a heater.

4.To protect the unit, DO NOT . . .

... allow it to become wet.

... drop the unit or strike it against hard objects.

... subject it to shock or excessive vibration during transportation.

... keep the lens directed at extremely bright objects for long periods.

... direct the eyepiece of the viewfinder at the sun.

... carry it by holding the viewfinder. Be sure to hold the main unit with both hands or use the grip.

... swing it excessively when using the shoulder strap.

5.Dirty heads can cause the following problems:

No picture and sound during playback (blue back screen).

Blocks of noise appear during playback.

During recording, the Head Clog Warning indicator “” appears.

In such cases, use the optional Cleaning Cassette. Insert it and play back. If the cassette is used more than once consecutively, damage to the video heads may result. After the camcorder plays back for about 20 seconds, it stops automatically. Also refer to the Cleaning Cassette’s instructions.

If, after using the Cleaning Cassette, the problems still exist, consult your nearest JVC dealer. Mechanical moving parts used to move the video heads and video tape tend to become dirty and worn out over time. In order to maintain a clear picture at all times, periodic check-ups are recommended after using the unit for about 1,000 hours. For periodic check-ups please consult your nearest JVC dealer.

About moisture condensation . . .

You may have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass’ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

Image 68
Contents GR-DVF1 Dear Customer Crossed Out Dust Bin MarkIt is recommended that you Crossed Out Dust BinAbout Batteries Analysis Mic Conversion Luminance Signal Y Lens Colour Difference Signal R-Y/B-YSignal Compression Contents Using the Battery Pack PowerCharging the Battery Pack Using AC Power Using a CAR BatteryCharge Marker Choose which one means charged and which means dischargedClock Lithium Battery Insertion/Removal Insert Battery in HolderRemove Battery Holder Pull out the battery holder RE-INSERT HolderDate/Time Settings Select Operation ModeAccess Recording Menu Access DATE/TIME MenuCont Loading/Unloading a CassetteOpen Cassette Cover INSERT/REMOVE TapeRecording Mode Setting SET Recording ModeFirst move the highlight bar to REC Mode by Set depending on your preferenceGrip Adjustment Viewfinder AdjustmentAdjust Length Shoulder Strap AttachmentTripod Mounting Attach StrapPower Switch Position Full Auto modePRO. mode Load a CassettePress Display Button Viewfinder IndicationsStop Recording Feature Picture Stabilizer Basic RecordingZoom Zoom OutFeature Video Light To brighten the scene when natural lighting is too dimBasic Features When blank portion is recorded on a tapeProper recording Minutes Seconds Frames Frames = 1 secondRecording Advanced Features EN19 Displaying The Date And Time During RecordingSelect Function SET Function ParametersAdvanced Features Snapshot Mode SelectionSnapshot Snapshot RecordingMotor Drive Mode EN21Using Menu For Detailed Adjustment Make SettingEND Setting Select Function Parameters in DATE/TIME Menu or System MenuFactory-preset Recording Menu ExplanationsDate/Time Menu Explanations System Menu ExplanationsFade/Wipe Effects Effect SelectionFADE/WIPE Selection B K , , B WPicture Wipe or Dissolve Selection P, P, P, P , P, P and P Start RecordingBefore the following steps, perform steps 1 through 3 on pg If you select Picture Wipe/Dissolve during recordingFader And Wipe Menu MenuRecording Advanced Features Select ModeDisable Mode Programme AE With Special EffectsShutter TwilightSepia MonotoneFocusing Auto FocusPatterns that are regularly repeated Focus detection zoneAccess Manual Mode Item Menu Access Manual FocusAdjust Focus END Adjustment of FocusAccess Exposure Control If you want to reset the exposure, repeat stepExposure Control To darken the imageIris Lock Centre SUBJECT, Lock IrisIris To Return To Automatic Iris ControlWhite Balance Adjustment Accessment White Balance AdjustSelect Auto in . Or set the Power Switch to To Return To Automatic White BalanceEnter Setting Manual White Balance OperationExit Manual White Balance AD- Justment To Change The Tint For RecordingPlayback Basic Playback Rewind or Fast-forward the tapePlay Back Stop PlaybackFeature Still Playback Feature Shuttle SearchFeature Slow-Motion Playback Feature Playback ZoomPlayback Menu Menu Button Select Dial Power Switch DisplayPlayback Menu Recording sound Display Output sound Playback SoundDisplaying The Time Code During Playback When connecting the cables, open this cover EN Playback ConnectionsUse the provided Audio/Video A/V cable Use the provided Audio/Video A/V cable and S-Video cableTurn on the camcorder, the VCR and the TV Connectinput VCR Output to TV Supply PowerConnectvcr Camcorder to TV or Tape Dubbing Installing The Battery Pull OUT Battery HolderRemote control uses one lithium battery CR2025 KnobWith the camcorder’s Power FunctionsButtons RM-V712U providedTo allow slow-speed search in either direction To stop Slow-Motion Playback in progess, press PlayPlayback Zoom Activate ZoomEND Zoom DownAccessmenu Playback Effect Select Playback Special EffectsStart Playback Select Playback EffectRandom Assemble Editing R.A.Edit SET REMOTE/VCR CodeSET Remote to Operate VCR Operate VCRMake Connections Select ScenesSelect Scenes USE FADE/WIPE on Scene Transition if NecessaryUSE Programme AE with Special Effects if Necessary Press FADE/WIPEStop Editing Automatic Editing to VCRPrepare Source Tape For More Accurate Editing Diagnosing VCR’S Against Camcorder TimingPrepare for R.A. Edit Choose a SceneAdjustment of VCR’S Against Camcorder Timing Access Playback MenuPower Switch Playback Menu Input Correction DataAudio Dubbing Begin DubbingPause During Dubbing Stop DubbingOriginal and new tracks are combined and output in stereo New track is output on both L and R channels in stereoCorrective Action Snapshot mode cannot be used Digital Zoom does not work Video mode Playback pgShutter mode of Programme When using Picture WipeTroubleshooting Recording. The effects areDisplay is set to OFF Disappear Than 1 second to makeWipe them gently with soft Cloth. Wiping strongly canBattery pack, etc., clock If the indication remainsEven though you repeat Above two or three timesCleaning The Camcorder After Use62EN Video Light Switch $ Power Switch Battery Release SwitchClock Battery Slot Tripod Mounting Socket Select Dial +, -, Push @ MENU/DISPLAY ButtonIndications Viewfinder Indications During RecordingFunction 444Viewfinder Indications During PlaybackIndications Function FunctionMonotone Motor Drive Mode Pg , 7Playback Menu Playback ZoomFor safety, do not Avoid using the unitTo avoid hazard During useDo not leave the unit To protect the unit, do notAbout moisture condensation Serious malfunctioningAC Power Adapter/Charger AA-V15EG ConnectorsCamcorder GeneralMemo Memo GR-DVF1