JVC LYT0192-001B manual Recording Sound Display Output Sound

EN67

NOTES:

●Audio dubbing is possible using an optional microphone connected to the external microphone input connector (MIC).

●While an optional microphone is connected, the built-in microphone is disabled.

●When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.

●To select the desired sound for playback, press AUDIO MONITOR on the remote control.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV Playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●To hear sound, connect optional headphones to the AV OUT (headphones) connector.

●If you change from 32 kHz to 48 kHz in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 48 kHz recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz or a blank portion, Audio Dubbing stops and “ERROR! REFER MANUAL” appears.

RECORDING SOUND	DISPLAY	OUTPUT SOUND
32 kHz	FULL SOUND	Original and new tracks are combined and output in stereo.
	SOUND 2	New track is output on both “L” and “R” channels in stereo.
	SOUND 1	Original track is output on both “L” and “R” channels in stereo.