NOTES:
● Fade-in/out cannot be performed during Time-Lapse shooting.
● For best results, keep the camcorder secured while shooting.
● If, during steps 3 and 4, the PROGRAM AE dial is set to the Self-Timer mode, the Self-Timer mode is engaged with 15S selected.
RELEASE TIME-LAPSE MODE
Press Recording Start/Stop. Recording and intervals alternate automatically.
5
6 To release when the tally lamp is not blinking, press INTERVAL and REC TIME repeatedly until “ ” and “ ” disappear. To release when the tally lamp is blinking, press Recording Start/Stop to stop the blinking, then press INTERVAL and REC TIME repeatedly until “ ” and “ ” disappear.
CHECK YOUR WORK
START TIME-LAPSE RECORDING
4 Press INTERVAL on the remote control. There are four choices available, and they appear in the following order (each time INTERVAL is pressed): 15S, 30S, 1MIN, and 5MIN. Press again to reset.
SET INTERVAL BETWEEN RECORDINGS
SET RECORDING TIME
Set SP/EP to SP (☞ pg. 11).
SET RECORDING SPEED
Make sure the lens cover is open, then set the power switch to CAMERA.
1
2
3 Press REC TIME on the remote control. There are three choices available, and they appear in the following order (each time REC TIME is pressed): 1/4S, 1/2S and 1S. Press again to reset.
ENGAGE RECORD–STANDBY MODE
You need the optional RM-V20U remote control unit to perform the following procedure.
NOTE:
You can record sequentially at preset time spans. Leaving the camcorder aimed at a specific subject, you can record subtle changes over an extended period of time.
5 Repeat steps pictures.
ASSEMBLE SERIES OF PICTURES
START RECORDING
4 Press Recording Start/Stop after focusing on the subject. The recording stops automatically after the selected period of time.
SET RECORDING TIME
Set SP/EP to SP (☞ pg. 11).
SET RECORDING SPEED
Make sure the lens cover is open, then set the power switch to CAMERA.
1
2
3 Press REC TIME on the remote control. Three choices are available, and they appear in the following order (each time REC TIME is pressed): 1/4S (one-fourth of a second), 1/2S (one-half of a second) and 1S (one full second). Press again to release the animation mode.
ENGAGE RECORD–STANDBY MODE
You need the optional RM-V20U remote control unit to perform the following procedure.
NOTE:
Give stationary scenes or objects an illusion of movement. This function allows you to shoot a series of pictures, each slightly different, of the same object for a brief period of time.
Animation
27
3 and 4 for the desired number of
6 Play back the series of pictures to see if the results were satisfactory.
RELEASE ANIMATION MODE
7 Press REC TIME until “
” disappears from the viewfinder.
NOTES:
●For best results, make sure the camcorder is secured when shooting.
●If the PROGRAM AE dial is set to
●