Memorex MCC215 manual Getting Started, Installing the Batteries

Page 8

GETTING STARTED

INSTALLING THE BATTERIES

Remove the battery compartment cover by sliding it off. Insert three (3) AAA batteries into the battery compartment, observing the polarity marks (+/–) as shown.

Slide the cover back on.

NOTE: When the batteries are low, the battery low indicator will blink in the display.

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:

1. Use only the size and type of batteries specified.

2. Be sure to follow the correct polarity when installing the batteries as indicated inside the battery compartment. Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

7

Image 8
Contents Video CameraDigital Contents Safety Precautions Safety Precautions USB Cable Part no REAR/INTERIORLOCATION of ControlsAV Cable Part no Handstrap Part NO. K910RDV096C0001 Battery Cover Part noLocation of Controls FRONT/SIDE Using the Strap Installing the Batteries Getting StartedGetting Started Turning the Power on and OFF Hints on Using AN SD/MMC Card Getting Started AN SD/MMC Memory Card UP to 2 GBOperation Taking a Single PictureChanging the Picture Mode Changing the Picture Resolution Changing the White Balance Changing the EV Compensation Viewing the Pictures Recording a Video Changing the Video Resolution Changing the White Balance Changing the EV Compensation Viewing the Videos Setting the Date and Time Setting the DATE/TIME Stamp on Pictures Formatting the SD/MMC Card Setting the Light Frequency Setting the PC CAMERA/MASS Storage Viewing the Version Setting the Icon Turning the Recorded Audio on and OFF During Video Playback Changing the TV System Default Setting Connecting the Unit to a TV Connecting Your Camera to Your PC Computer ConnectionSupported Operating Systems Software InstallationInstalling the PC Camera Driver Installing PhotoImpression and VideoImpression Downloading and Transferring Files Using Photoimpression Using Videoimpression Using the Unit AS a PC CAM On the NextUse the following icons to capture and save still photos Page Troubleshooting Guide Symptom Possible Cause SolutionPlayback as described on Formatting the Unit Formatting the PlayerResetting the Unit For Firmware UpgradeSpecifications 8MBPage Memorex, the Memorex logo,