Connecting to a PC or Printer
Connecting to a PC
You can load pictures recorded with the camera to a PC by connecting the camera and PC.
The software [LUMIX Simple Viewer]
(for Windows® ) in the
If you use Windows 98/98SE, install the USB driver and then connect it to the computer.
For details of [LUMIX Simple Viewer] and installation, refer to the separate operating instructions for PC connection.
1 Turn the camera on and then set [USB MODE] on the [SETUP] menu to [PC]. (P84)
•If you set [USB MODE] to [PictBridge (PTP)] and then connect the camera to the PC, messages may appear on the screen of the PC.
Select [Cancel] to close the indications and disconnect the camera from the PC. Connect the camera after you set [USB MODE] again.
2 Connect the camera to a PC via the USB connection cable A (supplied).
•Connect the USB connection cable with the [ ] mark facing the [2] mark on the [DIGITAL] socket.
•Hold the plug C to push into or pull out.
AV OUT
DIGITAL
DC IN
A: USB connection cable (supplied)
B: AC adaptor
•For using the AC adaptor
ACCESS
D: This message appears during data transfer.
[Windows]
The drive appears on the [My Computer] folder.
•If it is the first time you are connecting the camera to a PC, the required driver is installed automatically so that the camera can be recognised by the Windows Plug and Play, then it appears on the
[My Computer] folder.
[Macintosh]
The drive is displayed on the screen as [NO_NAME] or [Untitled].
85
VQT0R57