Panasonic HX-DC10 operating instructions 18 VQT3P31, During charging

2

SETUP

Use the USB cable (supplied) to connect the camera and the AC adaptor, and then connect the AC adaptor to a power outlet.

hUse only the supplied USB cable. Operation is not guaranteed if a different USB cable is used.

hThe AC adaptor is for this camera only. Do not use it with other devices.

hRecharging takes place only when the camera is turned off or is in the sleep mode (page 26 in the Operating Instructions (PDF format)). Recharging does not take place when the camera is in the recording mode or playback mode.

3 To power outlet

1 Open 2

AC adaptor

To AC adaptor

hThe unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet.

hDo not use any other AC adaptors except the supplied one. h Do not use any other USB cables except the supplied one.

<During charging...>

h The status indicator flashes red at 0.5-second intervals if the battery pack is defective or is not installed correctly. Make sure that the

battery pack is correctly installed.

h If the battery pack still fails to recharge, it is possible that there is a malfunction in the camera, the battery pack or the AC adaptor. In case the status indicator is flashing fast or slow, please see page 167 in the

Operating Instructions (PDF format).

h When charging is completed, the status indicator turns off. h The charging time is approx. 120 minutes.

Status indicator

18 VQT3P31