Before Use
3Close the Cassette Holder by pressing the [PUSH] mark 1.
1
PUSH
4Close the Cassette Compartment Cover.
ªAccidental Erasure Prevention
Opening the accidental erasure prevention slider 1 on the cassette (by sliding it to the [SAVE] arrow direction) prevents recording. To enable recording, close the accidental erasure prevention slider (by sliding it to the [REC] arrow direction).
1
R E C
SAVE
≥For other notes concerning this item, see
Using a Card
A Card can be used to record pictures.
3Close the Card Slot Cover (5) securely.
Removing the Card
Open the Card Slot Cover and press the centre of the Card and then pull it straight out.
≥After removing the Card, close the Card Slot Cover.
≥The Movie Camera may be damaged if the Card is forced out when the Card is fully inserted.
ªCard Access Lamp (17)
(17)
While the Movie Camera is accessing the Card (reading, recording, playback or erasing), Card Access Lamp lights up.
≥While Card Access Lamp is on, never attempt to open the Card Slot Cover, to pull out the Card, to turn off the Movie Camera, or to turn the Mode Dial. Such actions will damage the Card, and recorded data, and cause the Movie Camera to malfunction.
Turning on the Movie Camera
ªHow to Turn on the Power
1Set the [OFF/ON] Switch (46) to [ON] while pressing the button 1.
≥The [POWER] Lamp (47) lights up.
ªCaution before inserting/removing a
Card
Be sure to turn off the Movie Camera.
≥Otherwise, the Movie Camera may not function properly or it may cause the loss of recorded data in a Card.
ON
OFF 
(46)
(47)
1
ªInserting a Card
1Slide the [OPEN] Lever (3) to open the Card Slot Cover (5).
OPEN
(3)
(5)
2While holding the Memory Card with its cut corner facing right 1, insert it into the Card Slot (4).
(4)
1
ªHow to Turn off the Power
1Set the [OFF/ON] Switch (46) to [OFF] while pressing the button 1.
ON
OFF 
(46)1
Selecting Modes
You can choose a desired mode by rotating the Mode Dial.