Sony Ericsson CDP-XE570 Waveforms, BD Board, Schematic Diagram Loading Motor Section

CDP-XE570

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.

(In addition to this, the necessary note is printed in each block.)

For schematic diagrams.

Note:

•All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums.

•All resistors are in Ω and 1/4 W or less unless otherwise specified.

•f : internal component.

•C: panel designation.

Note: The components identified by mark 0or dotted line with mark 0are critical for safety.

Replace only with part number specified.

•A: B+ Line.

•B: B– Line.

•Voltages and waveforms are dc with respect to ground under no-signal (detuned) conditions.

no mark : STOP

( ) : PLAY

•Voltages are taken with a VOM (Input impedance 10 MΩ ). Voltage variations may be noted due to normal produc- tion tolerances.

•Waveforms are taken with a oscilloscope.

Voltage variations may be noted due to normal produc- tion tolerances.

•Circled numbers refer to waveforms.

•Signal path. J : CD c : digital out

For printed wiring boards.

Note:

•	X	: parts extracted from the component side.
•	Y	: parts extracted from the conductor side.
•	x	: parts mounted on the conductor side.
•		: Through hole.

•WAVEFORMS

– BD Board –

1 IC101 ta (RFAC)	5 IC101 wh (MDP)
	2.7 V
1.3 Vp-p	7.5 ∝ s
(CD Play Mode)	(CD Play Mode)
2 IC101 rd (RFD)	6 IC101 w; (SCOR)
	5.2 Vp-p
1.4 Vp-p	13.4 ms
(CD Play Mode)	(CD Play Mode)
3 IC101 el (FE)	7 IC101 yj (XTAO)
approx.	5.9 Vp-p
200 mVp-p
	59 ns
(CD Play Mode)	(CD Play Mode)
4 IC101 ra (TE)
approx.
400 mVp-p
(CD Play Mode)

6-2. SCHEMATIC DIAGRAM LOADING MOTOR SECTION

6-3. PRINTED WIRING BOARD LOADING MOTOR SECTION • See page 12 for Circuit Board Location.

a

• b: Pattern from the side which enables seeing.

(The other layers' patterns are not indicated.)

Caution:

Pattern face side: Parts on the pattern face side seen from the

(Side B) pattern face are indicated.

Parts face side: Parts on the parts face side seen from the

(Side A) parts face are indicated.

•Indication of transistor

C

	Q	These are omitted
B E

B C E

These are omitted

– DISPLAY Board –

8IC501 el (EXTAL)

4.5 Vp-p 40 ns

TO MAIN BOARD

(Page 16)

	LOADING BOARD
		S272
CN151		LOAD
		IN
5	S271
	LOAD
	OUT	M

	M151
1	LOADING
	MOTOR	11
		1 - 6 4 5 - 7 2 1 - (21)

1313