Samsung SCC-B5353N, SCC-B5352SN, SCC-B5352P, SCC-B5352N Setting switches, Setting function switches

Installation

❚Setting switches

Setting function switches

To set the available functions on your camera, adjust eight switches as shown below:

DEC	No	Name	Brief description
	1	LL	Line lock ON/OFF
8
	2	LSS	Sens-up or Low speed shutter ON/OFF
7
6	3	H-REV	Horizontal reverse ON/OFF
5	4	V-REV	Vertical reverse ON/OFF
4
	5	BLC	Backlight compensation ON/OFF
3
2	6	FL	Flickerless ON/OFF
1	7	D/N	Automatic switching between color and
			black & white ON/OFF
INC	8	AWB	Automatic white balance ON/OFF

1.Switch 1 (LL): When this switch is set to OFF, the camera operates in the internal synchronization mode, while when it is set to ON, the camera operates in the line lock mode. In the internal synchronization mode, the camera always uses an inside crystal oscillator for synchronization. However if multiple cameras are connected to a sequential switcher, picture rolling or flickering may occur when switching from one camera to another. In this case, you can set this switch to ON to solve this problem.

The line lock mode allows the camera to use the phase of the AC power as the synchronization reference. In this mode, you can use the phase control buttons(INC/DEC).

Note

When you are using the DC 12V power, set this switch to OFF. The line lock feature will not normally operate even when the switch is set to ON.

Set the LL switch to ON while the AC power is connected. If any picture roll happens, you have to adjust the phase using the phase-control buttons. Press the INC or DEC button to increase or decrease the phase by one degree.

10