LTC 9365 Series Instruction Manual Installation | EN 8 |
|
|
Right Angle
BNC Connector
Knockouts
Top Mount
Figure 2 Housing Bottom
4.Remove the camera bracket by loosening the two (2) 1/4in. bolts on either side of the bracket. The nuts are held in place by the bracket, allowing for
5.Remove one of the three knockouts on the bottom of the housing (see Figure 2). This will allow electrical and video cables to pass through.
6.Secure the housing using the previously marked mounting holes (hardware not included).
NOTE: If, in the course of this installation, you have detached the housing top from the housing bottom, be sure the top is reattached before securing the bottom in the desired location.
7.Install the camera on the camera bracket using the
NOTE: When installing the LTC 0300 & LTC 0400 Series cameras using the Top Mount Position, the camera must be inverted and the mounting foot must be relocated to the top of the camera by removing two small screws.
Bottom Mount
Figure 3 Installing the Camera - Top and Bottom Mounting Views
8.Make all the necessary electrical connections to the camera.
9.Make final adjustments to the camera angle and tighten the camera bracket.
10.Close the lower portion of the housing. The housing top will snap to the housing bottom and hold. This will allow you to tighten the two
(2)
Figure 4 Tightening the Security Screws
Bosch Security Systems, Inc. | Bosch Security Systems B.V. | Bosch Security Systems Pte Ltd. |
850 Greenfield Road | P.O. Box 80002 | 38C Jalan Pemimpin |
Lancaster, PA 17601 USA | 5600 JB Eindhoven | Singapore 577180 |
Tel: | The Netherlands | Republic of Singapore |
Fax: | Tele +31 40 27 80000 | Tel: 65 (6) 319 3486 |
www.boschsecuritysystems.com |
|
|
|
|
|
© 2004 Bosch Security Systems GmbH |
|
|
3935 890 37712