Useful Information
Adding extra Wireless Monitors (Pairing)
R A total of 4 Wireless Monitors (included Wireless Monitor + 3 additional Wireless Monitors (page 4)) can be used with a single Wireless Door Camera.
R Pair additional Wireless Monitors () to the Base Unit ().
1: Plug the AC adaptor of the Base Unit into the power outlet.
2: Press and hold the pair button (B) located on the bottom side of the Base Unit for about 3 seconds with a pointed object.
R Stop pressing the pair button (B) when the pair indicator (A) starts to slowly flash.
<Bottom view>
A
B
3: Place the additional Wireless Monitor () on the Base Unit (), and then press MMENUN.
R Press MMENUN within 2 minutes of performing step 2.
4: Press MN (Monitor button) to start pairing.
R When pairing is completed, “PAIRING COMPLETED” is displayed.
Note:
R Pairing cannot be performed when another Wireless Monitor is accessing the Base Unit (for monitoring or other purposes).
R The monitor number of the Wireless Monitor to be paired cannot be specified.
To pair canceled Wireless Monitors
R Perform the following operations within 2 minutes after pressing and holding the pair button of the
Base Unit () as explained in step 1 and 2 above.
1Press MMENUN.
2Select “ALL SETTINGS” by pressing arrow keys (MDN, MCN, MFN, or MEN), then press MN (Monitor button) (“OK”).
3Select “PAIRING/CANCEL” by pressing MDN or MCN, then press MN (Monitor button) (“OK”).
4 Select “PAIRING” by pressing MDN or MCN, then press MN (Monitor button) (“OK”). 5 Select “MONITOR”, then press MN (Monitor button) (“OK”).
6 Press MN (Monitor button).
7 To finish the operation, press MMENUN 2 times.
21