Panasonic WV-CF254 manual Setting Procedures, Camera Identification Camera ID Setting

SETTING PROCEDURES

1.Camera Identification (CAMERA ID) Setting

You can use the camera identification (CAMERA ID) to assign a name to the camera. The camera ID consists of up to 16 alphanumeric characters. You can select whether to have the camera ID dis- played on the monitor screen or not.

** CAM SET UP **

CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		---
AGC		ON
SYNC		INT
WHITE BAL		ATW	↵
END	SET UP ENABLE

To edit the CAMERA ID

1. Move the cursor to the CAMERA ID parameter.

2. Press (S). The CAMERA ID menu appears. The cursor on the letter “0” starts blinking.

Character Cursor

	0	123456789
		ABCDEFGHIJKLM	Character
	NOPQRSTUVWXYZ
().,'":;&#!?=			Area
+-*/%$
SPACE			Command
POSI RET END RESET
................			Editing
Pointer			Area

CAMERA ID menu

3. Move the cursor to the character you want to

change by pressing (L)/ (R)/ (U)/

(D).

4. After selecting the character, press (S). The selected character appears in the editing area. (The pointer in the editing area moves to the right automatically at this moment.)

5.Repeat the steps above until all characters are edited.

To enter a blank space in the CAMERA ID

Move the cursor to SPACE and press (S).

To edit a specific character in the CAMERA ID

1. Move the cursor to the editing area by press-

ing (S).

2. Move the pointer to the character to be edited

by pressing (L) or (R). Then move the cursor to the character area and select a new character.

3. Press (S) to determine the CAMERA ID.

To erase all characters in the editing area

Move the cursor to RESET and press (S). All characters in the editing area disappear.

To determine the display position of the

CAMERA ID

1.Move the cursor to POSI, and press (S). The display shown below appears and the CAMERA ID starts blinking.

Blinking

WV-CF254

2.Move the CAMERA ID to the desired position

by pressing (L)/ (R)/ (U)/ (D).

3.Press (S) to fix the position of the CAMERA ID. The mode returns to the previous CAMERA ID menu.

Notes:

•The CAMERA ID stops at the edges of the monitor screen.

•The CAMERA ID moves faster if any of

(L)/ (R)/ (U)/ (D) is kept pressed for a second or longer.

To return to the CAM SETUP menu

Move the cursor to RET and press (S). The CAM SETUP menu appears.

2. Light Control Setting (ALC/ELC)

You can select one of the following light control modes:

ALC: This camera has an ALC lens..

ELC: If you select this mode, the iris is kept open. Select a SHUTTER parameter to control the brightness.

** CAM SET UP **

CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		---
AGC		ON
SYNC		INT
WHITE BAL		ATW	↵
END	SET UP ENABLE

1.Move the cursor to the ALC/ELC parameter.

2.Select ALC or ELC.

-15-