Axis Communications 225FD manual Setting the IP address with ARP/Ping, Windows syntax

AXIS 225FD Installation Guide Page 13

Setting the IP address with ARP/Ping

1.Acquire an IP address on the same network segment your computer is connected to.

2.Locate the serial number (S/N) on the AXIS 225FD product label.

3.Open a Command Prompt on your computer and enter the following commands (as appropriate for your operating system):

Windows syntax:

arp -s <IP Address> <Serial Number> ping -l 408 -t <IP Address>

Windows example:

arp -s 192.168.0.125 00-40-8c-18-10-00 ping -l 408 -t 192.168.0.125

UNIX/Linux/Mac syntax:

arp -s <IP Address> <Serial Number> temp ping -s 408 <IP Address>

UNIX/Linux/Mac example:

arp -s 192.168.0.125 00:40:8c:18:10:00 temp ping -s 408 192.168.0.125

4.Check that the network cable is connected to the camera. Start/restart the camera by disconnecting and reconnecting power.

5.Close the Command prompt when you see ‘Reply from 192.168.0.125: ...’ or similar.

6.Start your browser, type in http://<IP address> in the Location/Address field and press Enter on your keyboard.

7.See page 9 for instructions on how to set the password.

Notes:

•The ARP/Ping command must be issued within 2 minutes of connecting power to the camera.

•To open a command prompt in Windows: from the Start menu, select Run... and type cmd (or command in Windows 98/ME). Click OK.

•To use the ARP command on a Mac OS X, use the Terminal utility, which is found under Application > Utilities.

ENGLISH