Cisco Systems 6400 manual Camera Installation Connecting External Power and I/O Cables

Chapter 2 Camera Installation

Connecting External Power and I/O Cables

Step 4 Feed the external power cable and I/O cables through the wall mount bracket and the waterproof connector components (E –> D –> B –> A). Be sure to feed enough cable length through the waterproof connector to connect the cables to the GPIO terminal block.

(A)

(B)

(D)

(E)

4

Note There are seven holes on the seal (B), and the widest hole with a crack on the side is specific for the power cable.

The recommended I/O cable gauge is 2.0 ~ 2.8 mm.

Step 5 Push the seal (B) into the housing (D), and to avoid moisture, insert the seals (C) into the empty holes on the seal (B).

(E)

(B) (C)

(D)

Cisco Video Surveillance 6400 IP Camera Installation Guide

2-6 OL-28494-01