Samsung SCC-C6405(P) manual Color/Bw, Sync

(CAMERA SET)
CAMERA ID	ON...	➜
V-SYNC	INT
COLOR/BW	COLOR	Press
MOTION DET	OFF
ZOOM SPEED	3	[Enter]
DIGITAL ZOOM	OFF
EXIT	QUIT

* " ... " Means there are Sub Menus.

(CAMERA ID)

AB C D E F G H I J K L M N O PQ R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9

:! - + ✽ ( ) /

SP ï î SP LOCATION...

RET

SCC-C6405P........

COLOR/BW

In the COLOR/BW menu, you can switch ON or OFF the IR (infrared) Filter.

In a poor illumination environment, the IR filter is turned off in the BW mode the its sensitivity increases as high as a black and white camera. On the other hand, the IR filter is turned on and the sensitivity decreases in the COLOR mode.

COLOR : The IR Filter is ON and the screen is normal.

BW : The IR Filter is OFF and the screen is black and white.

(Sensitivity to low light is increased to a level comparable to a black and white camera.)

V-SYNC

In the V-SYNC menu, vertical synchronization can be selected. The vertical synchronization signal supported by the SCC-C6405(P) is the INT mode made by clock inside the SCC-C6405(P) and LINE mode adjusting vertical synchronization to the exterior power frequency.

Select LINE and press [Enter]. You will see the LINE LOCK submenu where you can adjust the phase of the LINE LOCK.

You can use the PHASE menu of the LINE LOCK submenu to assign as much PHASE as you want.

Select BW and press [ENTER] and the additional menu to select BURST ON/OFF will appear.

AUTO : Select to automatically switch between the COLOR mode and BW mode depending on the amount of light. In low light conditions, the IR Filter is turned OFF and the sensitivity to low light is increased by switching to the BW mode, but in bright light conditions, the IR Filter is turned ON and the sensitivity is decreased by switching to the COLOR mode.

Select AUTO and press [ENTER] and the additional menu to select BW LEVEL and DURATION will appear.

- BURST ON : The color burst signal is output together with black and white

composite video signal.

- BURST OFF : The color burst signal is not output.

E

(CAMERA SET)
CAMERA ID	OFF
V-SYNC	LINE...
COLOR/BW	COLOR
MOTION DET	OFF
ZOOM SPEED	3
DIGITAL ZOOM	OFF
EXIT	QUIT

➜

Press [Enter]

(LL-PHASE)

PHASE (000)----I----

RET

- LEVEL	: You can set the brightness level that changes from COLOR mode
	to BW mode in 3 steps : LOW, MEDIUM, and HIGH.
- DURATION : Set the HOLDING time for switching between COLOR and BW
	mode depending the changes in the amount of light. You can set
	the HOLDING time to 10sec (S), 30sec, 60sec, or 300sec( L).

In AUTO mode, AGC will operates in high speed mode, and you cannot change it manually, as it is indicated by "---".

(CAMERA SET)
CAMERA ID	OFF
V-SYNC	INT
COLOR/BW	AUTO...
MOTION DET	OFF
ZOOM SPEED	0
DIGITAL ZOOM	0
EXIT	QUIT

➜

Press [Enter]

(AUTO)

BURST	ON
LEVEL	LOW
DURATION	S	------	L
RET

Caution : If you use an infrared light source while in AUTO mode, AUTO switching malfunction and camera AF malfunction may occur.

3-5 3-6