Fortinet 3016B manual Configuring Transparent mode, To modify the default gateway

Configuring Configuring Transparent mode

For an initial configuration, you must edit the factory configured static default route to specify a different default gateway for the FortiGate unit. This will enable the flow of data through the FortiGate unit.

For details on adding additional static routes, see the FortiGate Administration Guide.

To modify the default gateway

config router static edit <seq_num>

set gateway <gateway_IP> set device <interface>

end

Adding firewall policies

Firewall policies enable traffic to flow through the FortiGate interfaces. Firewall policies to define the FortiGate unit process the packets in a communication session. You can configure the firewall policies to allow only specific traffic, users and specific times when traffic is allowed.

For the initial installation, a single firewall policy that enables all traffic through will enable you to verify your configuration is working. On lower-end units such a default firewall policy is already in place. For the higher end FortiGate units, you will need to add a firewall policy.

The following steps add two policies that allows all traffic through the FortiGate unit, to enable you to continue testing the configuration on the network.

To add an outgoing traffic firewall policy

config firewall profile

edit <seq_num>

set srcintf <source_interface> set srcaddr <source_IP>

set dstintf <destination_interface> set dstaddr <destination_IP>

set schedule always set service ANY set action accept

end

To create an incoming traffic firewall policy, use the same commands with the addresses reversed.

Note that these policies allow all traffic through. No protection profiles have been applied. Ensure you create additional firewall policies to accommodate your network requirements.

Configuring Transparent mode

Configuring Transparent mode involves switching to Transparent mode, configuring the management IP address, default routes, and simple firewall policies. You can use the web-based manager or the CLI to configure the FortiGate unit in Transparent mode.

FortiGate-3016B FortiOS 3.0 MR6 Install Guide
01-30006-0458-20080318	25