Getting Started
Remote control preparation
The supplied lithium battery has already been inserted into the remote control. Pull out the protective sheet from the battery compartment to activate the battery. The remote control is now ready for use.
If the remote control stops working, follow the procedures below to replace the battery with a new one.
1.Place the Remote Control with the buttons facing downward.
2.While pressing the movable left part of the battery cover to the right, pull the tray out.
3.Place a CR2025 lithium battery on the tray with the positive + symbol face up.
4.Close the tray.
Note: Please ensure that the batteries are disposed of in accordance with local environmental legislation.
Connecting the power cable
1.Insert and screw the stand into the threaded insert at the rear of the unit to prop up the photo frame.
2.Use the supplied power adapter to connect the digital photo frame to an electrical outlet.
3.Slide the power switch on the back of the photo frame from OFF to ON.
Note:
yYou can leave the power switch on, and use the [
] button on the remote control to turn the frame on or to standby mode.
yTo turn off the power of the Digital Photo Frame completely, slide the power switch from ON to OFF.
User Manual PDJ077 page 6